How to Install and Configure the FlexPod Components CISCO-NETAPP-FLEXPOD-IMPLEMENTATION-ADMINISTRATION-SPECIALIST Practice Questions (Page 6)

Questions 26–28

1. 26application · medium

   A network engineer is configuring the Cisco Nexus switches for a FlexPod. The design requires that the storage and compute traffic be isolated at Layer 2. Which configuration should be used?

   • AConfigure a single port channel for all uplinks.
   • BEnable STP on the switches to prevent loops.
   • CCreate separate VLANs for storage and compute traffic and assign them to the appropriate switchports.
   • DUse the same VLAN for all traffic to simplify the configuration.
   Reveal Solution Discussion Select an answer first
2. 27application · medium

   A NetApp administrator is configuring a new AFF A220 for a FlexPod. The design requires separate SVMs for production and development workloads, each with its own logical interfaces (LIFs) and protocols. What must be created first to support this multi-tenant design?

   • AEnable the FlexGroup feature and create two FlexGroups for the tenants.
   • BCreate a single aggregate and then create two volumes, one for each tenant.
   • CCreate an SVM for each tenant and assign the appropriate aggregates and LIFs.
   • DConfigure a single SVM and use QoS policies to separate the workloads.
   Reveal Solution Discussion Select an answer first
3. 28foundation · easy

   Which command is used to verify physical connectivity on a Cisco Nexus switch?

   • Ashow version
   • Bshow running-config
   • Cshow vlan brief
   • Dshow interface status
   Reveal Solution Discussion Select an answer first