What is the purpose of Fibre Channel zoning in a FlexPod SAN boot configuration?

To set the boot order on the server.

To encrypt data between the server and storage.

To assign IP addresses to the storage ports.

To restrict which initiators can communicate with which storage ports.

What is the role of a vHBA in SAN boot on a Cisco UCS B-Series server?

It encrypts data in transit to the storage array.

It stores the boot LUN on the server's local disk.

It provides the Fibre Channel connectivity from the server to the SAN fabric.

It provides Ethernet connectivity for management traffic.

After configuring SAN boot on a UCS C-Series server, the server fails to boot and shows an error that no boot device is found. The administrator has verified that the LUN is mapped to the correct igroup and that zoning is correct. What should the administrator check next?

Check that the server's local disk is formatted and has a boot loader installed.

Ensure that the server's management IP address is reachable from the NetApp storage.

Verify that the boot policy in the UCS service profile is set to boot from the SAN LUN and that the LUN ID is correct.

Reboot the server and press F2 to enter the BIOS setup to manually select the boot device.

After configuring SAN boot, what should you verify to ensure the server boots from the SAN LUN?

The server's BIOS shows the LUN as a boot device and the OS loads from it.

The server's local disk is formatted with the OS.

The FC switch shows the server's WWPN in the zoning database.

The storage LUN is visible in the server's management console.

In Cisco UCS Manager, what is the purpose of a boot policy when configuring SAN boot?

It sets the admin password for the server's BIOS.

It assigns IP addresses to the server's management interfaces.

It defines the boot order and specifies the SAN LUN as the boot device.

It configures the Fibre Channel zoning on the SAN switches.

Cisco and NetApp Certified FlexPod Implementation and Administration Specialist

Domain 3Objective 3

How to Configure SAN Boot in a FlexPod Solution CISCO-NETAPP-FLEXPOD-IMPLEMENTATION-ADMINISTRATION-SPECIALIST Practice Questions (Page 1)

Part of the FlexPod Configuration domain, which makes up ~42% of our current practice bank.

24questions here

5free pages

7concepts

Questions 1–5

1foundation · easy
What is the purpose of Fibre Channel zoning in a FlexPod SAN boot configuration?
Select an answer first
2foundation · easy
What is the role of a vHBA in SAN boot on a Cisco UCS B-Series server?
Select an answer first
3application · medium
After configuring SAN boot on a UCS C-Series server, the server fails to boot and shows an error that no boot device is found. The administrator has verified that the LUN is mapped to the correct igroup and that zoning is correct. What should the administrator check next?
Select an answer first
4foundation · easy
After configuring SAN boot, what should you verify to ensure the server boots from the SAN LUN?
Select an answer first
5foundation · easy
In Cisco UCS Manager, what is the purpose of a boot policy when configuring SAN boot?
Select an answer first

Finished these 5 questions?

Review the revealed explanations, or continue through the curriculum.

Next 5 questions →Back to CISCO-NETAPP-FLEXPOD-IMPLEMENTATION-ADMINISTRATION-SPECIALIST

Free Basic Practice is a study aid with revealable answers — not a scored exam. Examers.io is independent and not affiliated with or endorsed by NetApp. “CISCO-NETAPP-FLEXPOD-IMPLEMENTATION-ADMINISTRATION-SPECIALIST” is a trademark of its owner, used for identification only.