A FlexPod administrator is configuring FC zoning for a new SAN boot deployment. The environment has two FC switches. Each UCS server has two vHBAs, and the NetApp storage has two FC target ports. What is the recommended zoning practice to ensure redundancy and proper SAN boot operation?

Create a single zone that includes all vHBAs and all target ports across both switches.

Do not configure zoning; rely on the storage's LUN masking to control access.

Zone each vHBA to only one target port, and use the other vHBA for a different purpose.

Create a zone for each vHBA and target port pair, ensuring that each vHBA is zoned to both target ports on the same switch.

A NetApp administrator is setting up SAN boot for a FlexPod environment. The administrator has created a LUN for the boot image and an igroup. What is the next step to ensure the server can boot from the LUN?

Create a new volume and assign it to the igroup.

Map the LUN to the igroup and ensure the igroup contains the WWPNs of the server's vHBAs.

Assign the LUN a SCSI ID and configure the server's boot policy to use that SCSI ID.

Enable the LUN for iSCSI and configure the igroup for iSCSI initiators.

In NetApp ONTAP, what is the purpose of an igroup when configuring SAN boot?

It sets the boot order for the server.

It configures the Fibre Channel switch zoning.

It defines which initiators are allowed to access specific LUNs.

It assigns an IP address to the LUN.

Which of the following is a required prerequisite for configuring SAN boot on a FlexPod UCS server?

A local RAID volume configured on the server's internal disks

An NTP server configured on the storage array

A configured boot policy that includes a SAN boot target

A management IP address assigned to the storage LUN

Which of the following is a common cause of a server not seeing a SAN boot LUN?

The server's local disk is too small.

The storage array's IP address is incorrect.

The server's management IP is not configured.

Incorrect zoning on the Fibre Channel switch

Cisco and NetApp Certified FlexPod Implementation and Administration Specialist

Domain 3Objective 3

How to Configure SAN Boot in a FlexPod Solution CISCO-NETAPP-FLEXPOD-IMPLEMENTATION-ADMINISTRATION-SPECIALIST Practice Questions (Page 3)

Part of the FlexPod Configuration domain, which makes up ~42% of our current practice bank.

24questions here

5free pages

7concepts

Questions 11–15

11application · medium
A FlexPod administrator is configuring FC zoning for a new SAN boot deployment. The environment has two FC switches. Each UCS server has two vHBAs, and the NetApp storage has two FC target ports. What is the recommended zoning practice to ensure redundancy and proper SAN boot operation?
Select an answer first
12application · medium
A NetApp administrator is setting up SAN boot for a FlexPod environment. The administrator has created a LUN for the boot image and an igroup. What is the next step to ensure the server can boot from the LUN?
Select an answer first
13foundation · easy
In NetApp ONTAP, what is the purpose of an igroup when configuring SAN boot?
Select an answer first
14foundation · easy
Which of the following is a required prerequisite for configuring SAN boot on a FlexPod UCS server?
Select an answer first
15foundation · easy
Which of the following is a common cause of a server not seeing a SAN boot LUN?
Select an answer first

Finished these 5 questions?

Review the revealed explanations, or continue through the curriculum.

Next 5 questions →Back to CISCO-NETAPP-FLEXPOD-IMPLEMENTATION-ADMINISTRATION-SPECIALIST

Free Basic Practice is a study aid with revealable answers — not a scored exam. Examers.io is independent and not affiliated with or endorsed by NetApp. “CISCO-NETAPP-FLEXPOD-IMPLEMENTATION-ADMINISTRATION-SPECIALIST” is a trademark of its owner, used for identification only.