How to Install and Configure the FlexPod Components CISCO-NETAPP-FLEXPOD-IMPLEMENTATION-ADMINISTRATION-SPECIALIST Practice Questions (Page 5)

Questions 21–25

1. 21foundation · easy

   Which software prerequisite is typically required before installing FlexPod components?

   • AA configured DNS server for the storage cluster
   • BA valid license for VMware vSphere
   • CA supported version of Cisco UCS Manager
   • DAn active internet connection for all components
   Reveal Solution Discussion Select an answer first
2. 22application · medium

   An administrator is deploying a FlexPod with Cisco UCS and wants to ensure that a server can boot from SAN using a LUN on the NetApp storage. Which UCS configuration is required?

   • ACreate a boot policy in the service profile that specifies the SAN boot target.
   • BConfigure a VSAN on the fabric interconnect and assign it to the server's vHBA.
   • CAssign a WWPN to the server's vHBA.
   • DEnable the FCoE feature on the UCS fabric interconnect.
   Reveal Solution Discussion Select an answer first
4. 23expert · hard

   A NetApp administrator is configuring a FlexPod with two SVMs for different departments. The storage team wants to ensure that each SVM has its own dedicated aggregates for performance isolation. However, the available disks are limited. What is the best way to achieve performance isolation without adding more disks?

   • ACreate two volumes in the same aggregate and assign one to each SVM.
   • BCreate two aggregates, each with a subset of the available disks, and assign one to each SVM.
   • CUse FlexGroup volumes to distribute the data across all disks.
   • DCreate a single aggregate and use QoS policies to limit the performance of each SVM.
   Reveal Solution Discussion Select an answer first
5. 24application · medium

   A data center is preparing to install a new FlexPod. The facility has a 42U rack, dual 208V AC power feeds, and a raised floor with under-floor cooling. The team is about to unbox the Cisco UCS fabric interconnects, chassis, and NetApp storage shelves. Which action should be taken first to ensure a successful installation?

   • AVerify that the rack has sufficient depth and that the power and cooling capacities meet the hardware specifications.
   • BConnect all fiber cables between the fabric interconnects and storage shelves before powering on any component.
   • CInstall the NetApp storage shelves first because they are the heaviest components and must be at the bottom of the rack.
   • DConfigure the Cisco UCS fabric interconnects with the desired VLANs and uplinks before racking the hardware.
   Reveal Solution Discussion Select an answer first
6. 25foundation · easy

   Before installing FlexPod components, which environmental requirement must be verified?

   • AThe data center has adequate cooling and power capacity
   • BThe storage system has been formatted with the latest ONTAP version
   • CThe rack has been painted with a non-conductive coating
   • DThe network switches have been pre-configured with all VLANs
   Reveal Solution Discussion Select an answer first