Describe the Initial Switch Set-Up Requirements POWEREDGE-MX-MODULAR-DEPLOY Practice Questions (Page 5)

Questions 21–24

1. 21application · medium

   After configuring an IOM, an admin wants to verify that the management interface is operational. The admin is connected via the console port. Which command should the admin use to check the management interface status?

   • Ashow logging
   • Bshow interfaces management
   • Cshow ip route
   • Dshow mac address-table
   Reveal Solution Discussion Select an answer first
2. 22application · medium

   An admin is configuring a new IOM and wants to set the hostname to 'MX-IOM-2'. The admin is in global configuration mode. Which command should the admin use?

   • Asystem-name MX-IOM-2
   • Bset hostname MX-IOM-2
   • Chostname MX-IOM-2
   • Dname MX-IOM-2
   Reveal Solution Discussion Select an answer first
4. 23foundation · easy

   Which management network access method is typically used to initially configure a Dell PowerEdge MX7000 fabric switch before any IP settings are applied?

   • ASerial console connection
   • BTelnet to the management port
   • CSSH over the management network
   • DHTTPS to the switch's default IP address
   Reveal Solution Discussion Select an answer first
5. 24foundation · easy

   When configuring the management IP address on a Dell PowerEdge MX7000 fabric switch, which additional setting is typically required to ensure the switch can be managed from a remote network?

   • ADefault gateway
   • BNTP server address
   • CDNS server address
   • DSNMP trap receiver address
   Reveal Solution Discussion Select an answer first