Describe the Initial Switch Set-Up Requirements POWEREDGE-MX-MODULAR-DEPLOY Practice Questions (Page 2)

Questions 6–10

1. 6expert · medium

   An admin has configured an IOM with a static IP address and management VLAN. The admin can ping the IOM from the management network, but cannot SSH to it. What is the most likely cause?

   • AThe default gateway is incorrect.
   • BSSH is not enabled on the IOM.
   • CThe IP address is incorrect.
   • DThe management VLAN is incorrect.
   Reveal Solution Discussion Select an answer first
2. 7expert · medium

   A company is deploying an MX7000 chassis with two IOMs. The management network uses a dedicated VLAN and static IP addressing. The admin wants to configure both IOMs with the same hostname. What is the potential issue?

   • ADuplicate hostnames can cause confusion in management tools and DNS.
   • BDuplicate hostnames will cause an IP address conflict.
   • CDuplicate hostnames will cause a spanning tree loop.
   • DDuplicate hostnames will prevent the IOMs from booting.
   Reveal Solution Discussion Select an answer first
4. 8application · medium

   An admin is configuring an IOM for the first time. The admin sets the hostname to 'MX-IOM-1', assigns an IP address, and sets the management VLAN. After applying the settings, the admin wants to ensure the settings persist after a reboot. What should the admin do?

   • ASave the running configuration to the startup configuration.
   • BCopy the startup configuration to the running configuration.
   • CReboot the switch to apply the settings.
   • DUse the 'write erase' command.
   Reveal Solution Discussion Select an answer first
5. 9expert · medium

   An admin is configuring an IOM and sets the management VLAN to 100. The admin then assigns an IP address of 192.168.1.10/24 to the management interface. The admin can ping the IOM from a workstation on the same subnet, but not from a workstation on a different subnet. What is the most likely cause?

   • ASSH is not enabled on the IOM.
   • BThe default gateway is not configured on the IOM.
   • CThe IP address is incorrect.
   • DThe management VLAN is incorrect.
   Reveal Solution Discussion Select an answer first
6. 10application · medium

   A remote admin needs to perform the initial configuration of an IOM in an MX7000 chassis. The admin is not physically at the data center. The IOM currently has no IP configuration. Which method should the admin use to access the switch management interface?

   • AUse the console port via a serial connection.
   • BUse Telnet to connect to the IOM's management port.
   • CUse SSH to connect to the IOM's default IP address.
   • DUse the MX7000 OME-Modular interface to access the IOM's console.
   Reveal Solution Discussion Select an answer first