An administrator is installing a second FEM into an MX7000 chassis that already has one FEM and two IOMs installed. The chassis is running production workloads. What is the correct procedure for installing the second FEM?

Remove the existing IOM to make room for the FEM

Install the FEM in the front bay and connect it to the mid-plane

Power down the chassis, install the FEM, and then power the chassis back on

Insert the FEM into an empty rear mid-bay and secure it with the release latch

Which of the following is a physical component of the Fabric Expander Module (FEM)?

A series of high-speed connectors that mate with the mid-plane

A set of drive bays for local storage

A dedicated management processor with an Ethernet port

A set of SFP+ ports for external fiber connections

How does the Fabric Expander Module (FEM) connect to the compute sleds in the MX7000 chassis?

Through the in-chassis switch, which then connects to the sleds via the FEM

Through external cables that run from the FEM to each sled

Through the mid-plane, which carries the fabric signals between the sleds and the FEM

Through a dedicated management network that uses Ethernet cables

Which best practice should be followed when deploying Fabric Expander Modules (FEMs) in an MX7000 chassis?

Use the FEM to provide power to the compute sleds

Install the FEM in the front bays for better airflow

Ensure the FEM firmware is compatible with the in-chassis switch firmware

Connect the FEM directly to the external network using fiber cables

An administrator notices that a compute sled connected to a Fabric Expander Module is not receiving a link. The FEM status in OpenManage Enterprise Modular (OME-M) shows the FEM as 'Online' but the sled's mezzanine port shows 'No Link'. What is the most likely cause of this issue?

The IOM is not configured with the correct VLAN

The FEM firmware is out of date

The mezzanine card is not seated properly in the compute sled

The FEM is not connected to the IOM

Dell PowerEdge MX Modular Deploy

Domain 4Objective 2

Implement the Fabric Expander Module with the In-Chassis Network Switch POWEREDGE-MX-MODULAR-DEPLOY Practice Questions (Page 1)

Part of the MX7000 Implementation domain, which accounts for 19% of the POWEREDGE-MX-MODULAR-DEPLOY exam.

30questions here

6free pages

7concepts

19%of the exam

Questions 1–5

1application · medium
An administrator is installing a second FEM into an MX7000 chassis that already has one FEM and two IOMs installed. The chassis is running production workloads. What is the correct procedure for installing the second FEM?
Select an answer first
2foundation · easy
Which of the following is a physical component of the Fabric Expander Module (FEM)?
Select an answer first
3foundation · easy
How does the Fabric Expander Module (FEM) connect to the compute sleds in the MX7000 chassis?
Select an answer first
4foundation · easy
Which best practice should be followed when deploying Fabric Expander Modules (FEMs) in an MX7000 chassis?
Select an answer first
5application · medium
An administrator notices that a compute sled connected to a Fabric Expander Module is not receiving a link. The FEM status in OpenManage Enterprise Modular (OME-M) shows the FEM as 'Online' but the sled's mezzanine port shows 'No Link'. What is the most likely cause of this issue?
Select an answer first

Finished these 5 questions?

Review the revealed explanations, or continue through the curriculum.

Next 5 questions →Back to POWEREDGE-MX-MODULAR-DEPLOY

Free Basic Practice is a study aid with revealable answers — not a scored exam. Examers.io is independent and not affiliated with or endorsed by Dell Technologies. “POWEREDGE-MX-MODULAR-DEPLOY” is a trademark of its owner, used for identification only.