Juniper NetworksCertified Specialist, Service Provider Routing and Switching (JNCIS-SP)
Domain 7Objective 9
Configure, Monitor, or Troubleshoot MPLS Forwarding and LSPs JN0-364 Practice Questions (Page 4)
Part of the Multiprotocol Label Switching (MPLS) domain, which makes up ~16% of our current practice bank. Juniper Networks does not publish an official question count, but from its 90-minute exam (~35–60 total, ~6–10 in this domain), expect 1–1 from this objective — we provide 26 practice questions to prepare you well beyond it. (estimate)
26questions here
6free pages
8concepts
Questions 16–20
- 16
Which Junos CLI command displays the status of RSVP-TE LSPs?
Select an answer first - 17
In an MPLS network, which component is used by an ingress LSR to determine the initial label stack for a packet entering an LSP?
Select an answer first - 18
You are tracing an MPLS packet through a network. The packet enters the ingress LSR, which pushes a label. The packet then traverses two transit LSRs before reaching the egress LSR. How many label operations (push, swap, or pop) are performed on the packet in total?
Select an answer first - 19
Which Junos CLI command is used to view the MPLS forwarding table?
Select an answer first - 20
You are verifying MPLS forwarding on a transit router. You want to see the incoming label, outgoing label, and the next-hop interface for all MPLS packets. Which command provides this information?
Select an answer first
Finished these 5 questions?
Review the revealed explanations, or continue through the curriculum.
Free Basic Practice is a study aid with revealable answers — not a scored exam. Examers.io is independent and not affiliated with or endorsed by Juniper Networks. “JN0-364” is a trademark of its owner, used for identification only.