Juniper NetworksCertified Specialist, Service Provider Routing and Switching (JNCIS-SP)
Domain 7Objective 9
Configure, Monitor, or Troubleshoot MPLS Forwarding and LSPs JN0-364 Practice Questions (Page 1)
Part of the Multiprotocol Label Switching (MPLS) domain, which makes up ~16% of our current practice bank. Juniper Networks does not publish an official question count, but from its 90-minute exam (~35–60 total, ~6–10 in this domain), expect 1–1 from this objective — we provide 26 practice questions to prepare you well beyond it. (estimate)
26questions here
6free pages
8concepts
Questions 1–5
- 1
Which Junos command is useful for troubleshooting MPLS forwarding issues by showing the label stack of packets?
Select an answer first - 2
You are troubleshooting an MPLS network where traffic is being dropped. You run 'show mpls forwarding-table' on a transit router and see the following entry: '100 200 ge-0/0/1.0'. You check the interface ge-0/0/1.0 and see that it is up. However, you notice that the next-hop router's MPLS forwarding table does not have an entry for incoming label 200. What is the most likely cause of the dropped traffic?
Select an answer first - 3
Which process is responsible for populating the MPLS forwarding table on a Junos device?
Select an answer first - 4
You are configuring an RSVP-TE LSP with a primary path and a secondary path for redundancy. The primary path is configured with a strict hop. The secondary path is configured with a loose hop. The primary path fails. What will happen?
Select an answer first - 5
What is the default path selection behavior for an LDP-based LSP?
Select an answer first
Finished these 5 questions?
Review the revealed explanations, or continue through the curriculum.
Free Basic Practice is a study aid with revealable answers — not a scored exam. Examers.io is independent and not affiliated with or endorsed by Juniper Networks. “JN0-364” is a trademark of its owner, used for identification only.