You want to set the next-hop for a generated route to a specific address. How can you achieve this in Junos?

By configuring a next-hop directly in the generated route statement

By applying a routing policy that sets the next-hop

By using the 'set next-hop' command in operational mode

By configuring a static route with the same prefix

In Junos, an aggregate route is installed in the routing table only when which condition is met?

The aggregate route is preferred over all contributing routes

The aggregate route is explicitly activated with the 'active' statement

At least one contributing route is present in the routing table

The aggregate route is imported from the forwarding table

What is the primary purpose of configuring an aggregate route in Junos?

To provide a backup route that is used only when the primary route fails

To summarize multiple more-specific routes into a single less-specific route

To dynamically learn routes from a neighboring router

To create a route that is always present in the routing table regardless of other routes

What is the primary use case for an aggregate route compared to a generated route in Junos?

Aggregate routes are used for IPv4, while generated routes are used for IPv6

Aggregate routes are used for BGP, while generated routes are used for OSPF

Aggregate routes are primarily used for route summarization and advertisement, while generated routes are used to create a route for traffic forwarding

Aggregate routes have a lower preference than generated routes

You need to configure a route for 172.16.0.0/12 that will be created only when a more-specific route within that range exists in the routing table. Which configuration should you use?

set routing-options static route 172.16.0.0/12

set routing-options aggregate route 172.16.0.0/12

set routing-options generate route 172.16.0.0/12

set routing-options generated route 172.16.0.0/12

Juniper NetworksCertified Specialist, Service Provider Routing and Switching (JNCIS-SP)

Domain 1Objective 1

Static, Aggregate, and Generated Routes JN0-364 Practice Questions (Page 1)

Part of the Protocol-Independent Routing domain, which makes up ~7% of our current practice bank. Juniper Networks does not publish an official question count, but from its 90-minute exam (~35–60 total, ~2–4 in this domain), expect 1–1 from this objective — we provide 12 practice questions to prepare you well beyond it. (estimate)

12questions here

3free pages

8concepts

8 Concepts in This Objective

Static route configuration
Static route preference and metrics
Static route validation and monitoring
Aggregate route configuration
Aggregate route behavior and contributions
Generated route configuration
Generated route policy and filtering
Comparison of static, aggregate, and generated routes

Questions 1–5

1foundation · easy
You want to set the next-hop for a generated route to a specific address. How can you achieve this in Junos?
Select an answer first
2foundation · medium
In Junos, an aggregate route is installed in the routing table only when which condition is met?
Select an answer first
3foundation · easy
What is the primary purpose of configuring an aggregate route in Junos?
Select an answer first
4foundation · easy
What is the primary use case for an aggregate route compared to a generated route in Junos?
Select an answer first
5foundation · easy
You need to configure a route for 172.16.0.0/12 that will be created only when a more-specific route within that range exists in the routing table. Which configuration should you use?
Select an answer first

Finished these 5 questions?

Review the revealed explanations, or continue through the curriculum.

Next 5 questions →Back to JN0-364

Free Basic Practice is a study aid with revealable answers — not a scored exam. Examers.io is independent and not affiliated with or endorsed by Juniper Networks. “JN0-364” is a trademark of its owner, used for identification only.