How can you modify the route preference for a specific protocol in Junos?

Using the 'preference' statement under the protocol's configuration

Using the 'weight' statement under the protocol's configuration

Using the 'metric' statement under the protocol's configuration

Using the 'priority' statement under the protocol's configuration

In Junos, what is the purpose of a routing policy?

To manage user authentication on the router

To control the advertisement and acceptance of routes

To configure the physical interface parameters

In Junos, what is the purpose of a route filter?

To set the preference of a route

To modify the next-hop of a route

To match routes based on prefix and prefix length

To change the metric of a route

A network engineer is troubleshooting a routing issue. The router has a static route to 10.0.0.0/8 with next hop 192.0.2.1, but traffic to 10.1.0.0/16 is not being forwarded as expected. The routing table shows the static route is active. What command should the engineer use to verify the actual forwarding path?

show route forwarding-table destination 10.1.0.0/16

show route advertising-protocol bgp 192.0.2.1

A service provider has two BGP peers: Peer A and Peer B. They want to prefer routes learned from Peer A over Peer B for all prefixes. What is the most efficient way to achieve this?

Set a lower preference on Peer B routes.

Set a higher AS path prepend on Peer B.

Set a lower MED on routes from Peer A.

Set a higher local preference on routes from Peer A.

Juniper NetworksCertified Specialist, Service Provider Routing and Switching (JNCIS-SP)

Domain 1Objective 6

Configure, Monitor, or Troubleshoot Protocol-Independent Routing JN0-364 Practice Questions (Page 1)

Part of the Protocol-Independent Routing domain, which makes up ~7% of our current practice bank. Juniper Networks does not publish an official question count, but from its 90-minute exam (~35–60 total, ~2–4 in this domain), expect 1–1 from this objective — we provide 19 practice questions to prepare you well beyond it. (estimate)

19questions here

4free pages

7concepts

Questions 1–5

1foundation · easy
How can you modify the route preference for a specific protocol in Junos?
Select an answer first
2foundation · easy
In Junos, what is the purpose of a routing policy?
Select an answer first
3foundation · easy
In Junos, what is the purpose of a route filter?
Select an answer first
4application · medium
A network engineer is troubleshooting a routing issue. The router has a static route to 10.0.0.0/8 with next hop 192.0.2.1, but traffic to 10.1.0.0/16 is not being forwarded as expected. The routing table shows the static route is active. What command should the engineer use to verify the actual forwarding path?
Select an answer first
5application · medium
A service provider has two BGP peers: Peer A and Peer B. They want to prefer routes learned from Peer A over Peer B for all prefixes. What is the most efficient way to achieve this?
Select an answer first

Finished these 5 questions?

Review the revealed explanations, or continue through the curriculum.

Next 5 questions →Back to JN0-364

Free Basic Practice is a study aid with revealable answers — not a scored exam. Examers.io is independent and not affiliated with or endorsed by Juniper Networks. “JN0-364” is a trademark of its owner, used for identification only.