Which Junos command is used to enable tracing for routing protocol events?

set protocols ospf traceoptions file ospf-trace

monitor traffic interface ge-0/0/0

A router has four equal-cost paths to a destination, all learned via OSPF. The network team wants to load-balance traffic across all four paths, but they notice that only two paths are being used. They have already verified that all four paths have the same metric and preference. What is the most likely cause?

The OSPF metric is different on two paths.

The maximum-paths limit is set to 2.

The load-balancing mode is per-packet.

The routes have different preferences.

A service provider has a router with two paths to a customer edge: a primary path via a BGP-learned route (preference 170) and a backup path via a static route (preference 5). The network team wants the static route to be used only if the BGP route is withdrawn. They configure a static route with a next hop of 192.0.2.1 and apply a routing policy to set the preference of the static route to 200. What is the effect of this configuration?

Both routes are installed in the routing table, and traffic is load-balanced between them.

The static route is rejected because its preference cannot be modified.

The BGP route is preferred because its preference (170) is lower than the static route's preference (200).

The static route is preferred over BGP because static routes always have a lower preference.

Juniper NetworksCertified Specialist, Service Provider Routing and Switching (JNCIS-SP)

Domain 1Objective 6

Configure, Monitor, or Troubleshoot Protocol-Independent Routing JN0-364 Practice Questions (Page 3)

Part of the Protocol-Independent Routing domain, which makes up ~7% of our current practice bank. Juniper Networks does not publish an official question count, but from its 90-minute exam (~35–60 total, ~2–4 in this domain), expect 1–1 from this objective — we provide 19 practice questions to prepare you well beyond it. (estimate)

19questions here

4free pages

7concepts

Questions 11–15

11foundation · easy
Which Junos command is used to enable tracing for routing protocol events?
Select an answer first
12foundation · easy
Which command displays the current state of OSPF neighbors on a Junos device?
Select an answer first
13expert · medium
A router has four equal-cost paths to a destination, all learned via OSPF. The network team wants to load-balance traffic across all four paths, but they notice that only two paths are being used. They have already verified that all four paths have the same metric and preference. What is the most likely cause?
Select an answer first
14application · medium
A service provider has a router with two paths to a customer edge: a primary path via a BGP-learned route (preference 170) and a backup path via a static route (preference 5). The network team wants the static route to be used only if the BGP route is withdrawn. They configure a static route with a next hop of 192.0.2.1 and apply a routing policy to set the preference of the static route to 200. What is the effect of this configuration?
Select an answer first
15foundation · easy
Which routing protocol is an exterior gateway protocol (EGP) used to exchange routes between autonomous systems?
Select an answer first

Finished these 5 questions?

Review the revealed explanations, or continue through the curriculum.

Next 5 questions →Back to JN0-364

Free Basic Practice is a study aid with revealable answers — not a scored exam. Examers.io is independent and not affiliated with or endorsed by Juniper Networks. “JN0-364” is a trademark of its owner, used for identification only.

Configure, Monitor, or Troubleshoot Protocol-Independent Routing JN0-364 Practice Questions (Page 3)

Questions 11–15

Which Junos command is used to enable tracing for routing protocol events?

Which command displays the current state of OSPF neighbors on a Junos device?

Which routing protocol is an exterior gateway protocol (EGP) used to exchange routes between autonomous systems?

Keep studying — Protocol-Independent Routing