You have configured a static route and want to see detailed information about it, including its preference, metric, and next-hop. Which command provides this detailed route information?

show route advertising-protocol static

You have configured a generated route for 10.0.0.0/8. You want only routes from the OSPF protocol to contribute to this generated route. What should you use to control which routes contribute?

A firewall filter applied to the loopback interface

The 'contributing-routes' statement in the generated route configuration

A static route with a higher preference

A routing policy applied to the generated route

What is the key difference between a generated route and a static route in Junos?

A generated route is only present when contributing routes exist, while a static route is always present

A generated route requires a next-hop, while a static route does not

A generated route has a lower preference than a static route

A generated route can only be used for IPv6, while a static route can be used for IPv4

After configuring a static route, you want to verify that it has been installed in the routing table. Which command displays the routing table entries, including static routes?

show configuration routing-options

Juniper NetworksCertified Specialist, Service Provider Routing and Switching (JNCIS-SP)

Domain 1Objective 1

Static, Aggregate, and Generated Routes JN0-364 Practice Questions (Page 2)

Part of the Protocol-Independent Routing domain, which makes up ~7% of our current practice bank. Juniper Networks does not publish an official question count, but from its 90-minute exam (~35–60 total, ~2–4 in this domain), expect 1–1 from this objective — we provide 12 practice questions to prepare you well beyond it. (estimate)

12questions here

3free pages

8concepts

8 Concepts in This Objective

Static route configuration
Static route preference and metrics
Static route validation and monitoring
Aggregate route configuration
Aggregate route behavior and contributions
Generated route configuration
Generated route policy and filtering
Comparison of static, aggregate, and generated routes

Questions 6–10

6foundation · easy
A network administrator wants to configure a static route that will silently discard any traffic destined for the 203.0.113.0/24 network. Which next-hop option should be used in the static route configuration?
Select an answer first
7foundation · easy
You have configured a static route and want to see detailed information about it, including its preference, metric, and next-hop. Which command provides this detailed route information?
Select an answer first
8foundation · easy
You have configured a generated route for 10.0.0.0/8. You want only routes from the OSPF protocol to contribute to this generated route. What should you use to control which routes contribute?
Select an answer first
9foundation · easy
What is the key difference between a generated route and a static route in Junos?
Select an answer first
10foundation · easy
After configuring a static route, you want to verify that it has been installed in the routing table. Which command displays the routing table entries, including static routes?
Select an answer first

Finished these 5 questions?

Review the revealed explanations, or continue through the curriculum.

Next 5 questions →Back to JN0-364

Free Basic Practice is a study aid with revealable answers — not a scored exam. Examers.io is independent and not affiliated with or endorsed by Juniper Networks. “JN0-364” is a trademark of its owner, used for identification only.