Configure and Verify Static Routing SONIC-DEPLOY Practice Questions (Page 2)

Questions 6–8

1. 6application · easy

   A Dell SONiC switch has two static routes to the same destination 172.16.0.0/16. Route A uses next-hop 10.0.0.1 with an administrative distance of 50. Route B uses next-hop 10.0.0.2 with an administrative distance of 100. Which route will be preferred and installed in the routing table?

   • ANeither route will be installed because they are static.
   • BRoute A, because it has the lower administrative distance.
   • CBoth routes will be installed and load-balanced.
   • DRoute B, because it has the higher administrative distance.
   Reveal Solution Discussion Select an answer first
2. 7expert · hard

   A Dell SONiC switch has a static route to 10.0.0.0/8 with next-hop 192.168.1.1 and an administrative distance of 150. The switch also runs OSPF, which has learned a route to 10.0.0.0/8 with a metric of 20. Which route will be preferred and installed in the routing table?

   • AThe static route, because it has a lower metric.
   • BThe OSPF route, because it has a lower administrative distance.
   • CBoth routes will be installed and load-balanced.
   • DThe static route, because static routes are always preferred.
   Reveal Solution Discussion Select an answer first
3. 8foundation · medium · select all that apply

   When configuring a static route on a Dell SONiC switch, which two methods can be used to specify the path to the destination network?

   • ASpecify the exit interface name, such as Ethernet0 or PortChannel1.
   • BSpecify the VLAN ID of the destination network to enable inter-VLAN routing.
   • CSpecify the destination network's MAC address to enable Layer 2 forwarding.
   • DSpecify the source IP address to be used in the IP header of forwarded packets.
   • ESpecify the next-hop IP address of a directly connected neighbor.
   Check answers Discussion Select an answer first