Interface Configuration SONIC-DEPLOY Practice Questions (Page 1)

Questions 1–5

1. 1expert · medium

   An admin is configuring a trunk port between two switches. The port is a 100GbE port that has been broken out into four 25GbE ports. The admin wants to use all four breakout ports as a single logical trunk to the downstream switch, which also has four 25GbE ports. What is the correct approach?

   • AConfigure the parent 100GbE port as a trunk and expect the breakout ports to inherit the config.
   • BUse a port profile to apply the trunk config to the parent port only.
   • CCreate a port group with the four breakout ports and configure the trunk on the port group.
   • DConfigure each of the four breakout ports as a trunk with the same VLAN list.
   Reveal Solution Discussion Select an answer first
2. 2expert · medium

   An admin is deploying a new switch model. The admin has a standard port profile for server access ports that includes a specific MTU and storm-control settings. The admin applies the profile to a port that has been broken out into four 10GbE ports. The admin notices that the profile was applied to the parent port, not the child ports. What is the most likely outcome?

   • AThe child ports do not receive the profile settings, and the admin must apply the profile to each child port.
   • BThe profile is applied to the port group that contains the parent port.
   • CThe profile application fails because the parent port is not a valid interface.
   • DThe child ports automatically inherit the profile settings from the parent.
   Reveal Solution Discussion Select an answer first
4. 3foundation · easy

   Which command is used to verify the VLAN trunk configuration on a Dell SONiC interface?

   • Ashow interfaces trunk
   • Bshow interfaces status
   • Cshow running-config vlan
   • Dshow vlan brief
   Reveal Solution Discussion Select an answer first
5. 4foundation · easy

   In Dell SONiC, what is the primary purpose of a port profile?

   • ATo assign a specific IP address to a physical port for management purposes
   • BTo group multiple physical ports into a single logical link for increased bandwidth
   • CTo define a set of interface configuration attributes that can be applied to multiple physical ports
   • DTo enable a physical port to automatically negotiate speed and duplex with a connected device
   Reveal Solution Discussion Select an answer first
6. 5foundation · easy

   Which command is used to verify the current breakout mode of an interface on Dell SONiC?

   • Ashow interfaces transceiver
   • Bshow running-config interfaces
   • Cshow interfaces breakout
   • Dshow interfaces status
   Reveal Solution Discussion Select an answer first