Configure and Verify BGP SONIC-DEPLOY Practice Questions (Page 1)

Questions 1–5

1. 1foundation · easy

   In Dell SONiC, which command is used to enter BGP configuration mode for a specific autonomous system?

   • Aconfigure terminal bgp <AS-number>
   • Bbgp router <AS-number>
   • Crouter bgp <AS-number>
   • Dip bgp <AS-number>
   Reveal Solution Discussion Select an answer first
2. 2foundation · easy

   When a BGP router receives multiple routes for the same prefix, which attribute is evaluated FIRST in the best-path selection process?

   • AHighest Local Preference (Local-Pref)
   • BAS Path Length
   • CLocal Preference (Local-Pref)
   • DShortest MED (Multi-Exit Discriminator)
   Reveal Solution Discussion Select an answer first
4. 3application · medium

   A Dell SONiC switch has two eBGP paths to the same destination prefix. The engineer wants to prefer the path from neighbor 192.0.2.1 for inbound traffic from the ISP. Which attribute should be set on the routes advertised to that neighbor?

   • AAS-path prepend
   • Blocal-preference
   • Cweight
   • DMED
   Reveal Solution Discussion Select an answer first
5. 4foundation · easy

   What is the primary difference between advertising routes with the 'network' command and using 'redistribute' in BGP?

   • AThe 'network' command creates a new route, while 'redistribute' only advertises existing routes.
   • BThe 'network' command is used for eBGP, while 'redistribute' is used for iBGP.
   • CThe 'network' command is used for IPv4, while 'redistribute' is used for IPv6.
   • DThe 'network' command advertises only exact-match prefixes, while 'redistribute' can advertise all routes from a source protocol.
   Reveal Solution Discussion Select an answer first
6. 5foundation · easy

   Which Dell SONiC command displays the current BGP neighbor states and their session information?

   • Ashow running-config bgp
   • Bshow ip route bgp
   • Cshow bgp neighbors <ip>
   • Dshow bgp summary
   Reveal Solution Discussion Select an answer first