Configure and Verify a Single Area OSPF Topology SONIC-DEPLOY Practice Questions (Page 2)

Questions 6–10

1. 6foundation · easy

   What is the effect of the 'ip ospf 1 area 0' command when applied to an interface on a Dell SONiC switch?

   • AIt enables OSPF process 1 on the interface and places it in area 0.
   • BIt configures the interface as a passive interface in area 0.
   • CIt creates a new OSPF process and assigns it to area 0.
   • DIt removes OSPF from the interface and places it in area 0.
   Reveal Solution Discussion Select an answer first
2. 7foundation · easy

   What is the default OSPF router ID on a Dell SONiC switch if it is not explicitly configured?

   • AThe highest IP address on a loopback interface, or if none, the highest IP address on any active interface.
   • BThe lowest IP address on any active interface.
   • CThe MAC address of the first Ethernet interface.
   • DA randomly generated number that changes on every reboot.
   Reveal Solution Discussion Select an answer first
4. 8foundation · easy

   In a Dell SONiC OSPF configuration, which network type is typically used for Ethernet interfaces connecting to a multi-access network?

   • ABroadcast
   • BNon-broadcast
   • CPoint-to-multipoint
   • DPoint-to-point
   Reveal Solution Discussion Select an answer first
5. 9application · medium

   An engineer has configured OSPF on a Dell SONiC switch and verified that the neighbor adjacency is Full. However, the route to a remote subnet is not present in the routing table. What is the most likely cause?

   • AThe OSPF process is not enabled globally on the remote switch.
   • BThe remote switch's router ID is not reachable.
   • CThe remote subnet is not advertised into OSPF because it is not included in a network statement.
   • DThe OSPF network type is point-to-point, which prevents route advertisement.
   Reveal Solution Discussion Select an answer first
6. 10foundation · easy

   Which command is used to verify that OSPF routes are installed in the routing table on a Dell SONiC switch?

   • Ashow ip route all
   • Bshow ip route ospf
   • Cshow ip ospf route
   • Dshow ip ospf database
   Reveal Solution Discussion Select an answer first