Describe the Operation and Behavior of the Virtual Router Redundancy Protocol POWERSWITCH-CAMPUS-DEPLOY Practice Questions (Page 3)

Questions 11–15

1. 11foundation · easy

   When the original master router recovers and preemption is enabled, what occurs?

   • AThe recovered router remains in Backup state
   • BThe virtual IP address is changed to avoid conflicts
   • CAll routers restart the election process from scratch
   • DThe recovered router becomes master again because it has a higher priority
   Reveal Solution Discussion Select an answer first
2. 12expert · medium

   A network administrator wants to implement VRRP load sharing across two Dell PowerSwitch switches for two VLANs. The administrator configures virtual router 10 on VLAN 10 with virtual IP 192.168.10.1 and virtual router 20 on VLAN 20 with virtual IP 192.168.20.1. Switch A is the master for virtual router 10, and switch B is the master for virtual router 20. What is the primary advantage of this configuration?

   • AIt allows both switches to forward traffic for the same VLAN simultaneously.
   • BIt eliminates the need for Spanning Tree Protocol on the access layer.
   • CIt provides redundancy for both VLANs while utilizing both switches for forwarding traffic.
   • DIt reduces the master-down timer, allowing faster failover.
   Reveal Solution Discussion Select an answer first
4. 13expert · hard

   A network administrator is troubleshooting a VRRP issue on a pair of Dell PowerSwitch switches. The administrator notices that the backup switch is transitioning to the Master state and then back to the Backup state repeatedly. What is the most likely cause of this flapping behavior?

   • AThe backup switch has a higher priority than the master switch.
   • BThe master switch is intermittently failing to send advertisements.
   • CThe master-down timer is set too low.
   • DThe virtual router ID is configured differently on the two switches.
   Reveal Solution Discussion Select an answer first
5. 14application · medium

   A network administrator wants to load-balance traffic across two Dell PowerSwitch switches that serve as default gateways for two different VLANs. The administrator configures VRRP virtual router 10 with virtual IP 192.168.10.1 on VLAN 10 and virtual router 20 with virtual IP 192.168.20.1 on VLAN 20. Switch A is the master for virtual router 10, and switch B is the master for virtual router 20. What is this configuration called?

   • AVRRP load sharing
   • BVRRP preemption
   • CVRRP redundancy group
   • DVRRP failover
   Reveal Solution Discussion Select an answer first
6. 15foundation · easy

   In which VRRP state does a router send periodic advertisements?

   • ABackup
   • BInitialize
   • CMaster
   • DStandby
   Reveal Solution Discussion Select an answer first