Identify the Components and Use Cases for Virtual Router Redundancy Protocol POWERSWITCH-CAMPUS-DEPLOY Practice Questions (Page 1)

Questions 1–5

1. 1foundation · easy

   Which VRRP component is responsible for forwarding traffic sent to the virtual IP address?

   • AVirtual IP address
   • BBackup router
   • CVirtual router
   • DMaster router
   Reveal Solution Discussion Select an answer first
2. 2expert · hard

   A network administrator is configuring VRRP on a pair of Dell PowerSwitch routers. They want to ensure that if the master router's uplink fails, the backup router takes over. Which VRRP feature should they use?

   • AObject tracking on the uplink interface
   • BA higher priority on the backup router
   • CA different virtual IP address on the backup
   • DA lower advertisement interval on the master
   Reveal Solution Discussion Select an answer first
4. 3foundation · easy

   What is the primary purpose of Virtual Router Redundancy Protocol (VRRP) in a campus network?

   • ATo dynamically assign IP addresses to end devices on the network
   • BTo provide redundant default gateway services for end devices
   • CTo encrypt traffic between end devices and the default gateway
   • DTo enable load balancing of traffic across multiple equal-cost paths
   Reveal Solution Discussion Select an answer first
5. 4expert · hard

   A network engineer is configuring VRRP on two Dell PowerSwitch routers. They want to ensure that Router A is the master for VLAN 10 and Router B is the master for VLAN 20, while both provide backup for each other. How should they configure VRRP?

   • ACreate two VRRP groups, one per VLAN, with Router A having higher priority in VLAN 10 and Router B having higher priority in VLAN 20.
   • BUse the same virtual IP for both VLANs.
   • CCreate a single VRRP group for both VLANs with Router A as master.
   • DSet Router B as the master for both VLANs.
   Reveal Solution Discussion Select an answer first
6. 5application · easy

   A company has a pair of Dell PowerSwitch routers acting as the default gateway for a floor of 200 users. The network team wants to ensure that if the active router fails, the standby router takes over the virtual IP without any changes to the end devices. What is the primary purpose of VRRP in this scenario?

   • ATo segment the network into multiple broadcast domains
   • BTo increase the throughput of the gateway by using both routers
   • CTo encrypt traffic between the routers and end devices
   • DTo provide a redundant default gateway that automatically fails over
   Reveal Solution Discussion Select an answer first