Describe the Operation and Behavior of the Virtual Router Redundancy Protocol POWERSWITCH-CAMPUS-DEPLOY Practice Questions (Page 1)

Questions 1–5

1. 1expert · medium

   A network engineer is analyzing a packet capture of VRRP advertisements on a Dell PowerSwitch network. The engineer sees that the source MAC address of the advertisements is 00:00:5E:00:01:0A. What does this MAC address indicate?

   • AIt is the multicast MAC address used for VRRP advertisements.
   • BIt is the virtual MAC address for VRRP virtual router 10.
   • CIt is the broadcast MAC address used for VRRP advertisements.
   • DIt is the physical MAC address of the master router.
   Reveal Solution Discussion Select an answer first
2. 2foundation · easy

   What is the primary purpose of VRRP on a LAN segment?

   • ATo filter malicious traffic between VLANs
   • BTo provide a redundant default gateway for end hosts
   • CTo distribute IP addresses dynamically to end hosts
   • DTo enable routing between different subnets
   Reveal Solution Discussion Select an answer first
4. 3application · medium

   A VRRP-enabled Dell PowerSwitch is booting up. The switch has a priority of 150 and is configured with a virtual IP address. What is the correct sequence of VRRP states this switch will transition through before it becomes the master?

   • ABackup → Initialize → Master
   • BMaster → Backup → Initialize
   • CInitialize → Backup → Master
   • DInitialize → Master → Backup
   Reveal Solution Discussion Select an answer first
5. 4expert · medium

   A network administrator is designing a high-availability solution for a campus network. The administrator has two Dell PowerSwitch switches that will serve as default gateways for client VLANs. The administrator wants to ensure that if one switch fails, the other switch takes over the default gateway role without any client configuration changes. Which technology should the administrator implement?

   • ASpanning Tree Protocol (STP)
   • BLink Aggregation Control Protocol (LACP)
   • CDynamic Host Configuration Protocol (DHCP)
   • DVRRP
   Reveal Solution Discussion Select an answer first
6. 5application · medium

   A network administrator is configuring VRRP on two Dell PowerSwitch switches. The administrator wants to ensure that switch A is always the master when it is available. Switch A has a priority of 150, and switch B has a priority of 100. What additional configuration is required on switch A to ensure it becomes master if switch B was the first to boot?

   • AConfigure a higher priority on switch B
   • BEnable preemption on switch A
   • CSet a lower advertisement interval on switch A
   • DDisable preemption on switch B
   Reveal Solution Discussion Select an answer first