Configure and Verify the Operation of the Virtual Router Redundancy Protocol POWERSWITCH-CAMPUS-DEPLOY Practice Questions (Page 1)

Questions 1–5

1. 1foundation · easy

   In a VRRP group with two routers, what are the possible roles for each router?

   • APrimary and secondary
   • BMaster and backup
   • CForwarder and responder
   • DActive and standby
   Reveal Solution Discussion Select an answer first
2. 2expert · medium

   A network administrator is configuring VRRP on two Dell PowerSwitch switches. The administrator wants to ensure that if the master switch loses its uplink to the core network, the backup switch takes over as master. What is the best way to achieve this?

   • AConfigure the virtual IP to be different on the two switches.
   • BConfigure a shorter advertisement interval on the master.
   • CEnable preemption on the backup switch.
   • DUse a tracking object to decrement the priority of the master when the uplink goes down.
   Reveal Solution Discussion Select an answer first
4. 3foundation · easy

   Which command is used on a Dell PowerSwitch interface to enable VRRP and set the virtual router ID?

   • Avrrp 10 enable
   • Bvrrp-group 10
   • Cip vrrp 10
   • Drouter vrrp 10
   Reveal Solution Discussion Select an answer first
5. 4application · medium

   A network administrator is configuring VRRP on a Dell PowerSwitch for VLAN 30. The administrator wants to ensure that if the master switch fails, the backup switch takes over quickly. What is the most important configuration parameter to adjust to achieve a faster failover?

   • AEnable preemption on the backup switch.
   • BIncrease the priority on the backup switch.
   • CIncrease the advertisement interval on the master.
   • DDecrease the advertisement interval on the master.
   Reveal Solution Discussion Select an answer first
6. 5application · easy

   A network administrator is configuring VRRP on two Dell PowerSwitch switches to provide default gateway redundancy for a new VLAN. The administrator wants to ensure that hosts can reach the gateway even if one switch fails. What is the primary purpose of configuring the same virtual IP address on both switches?

   • ATo allow the switches to share the traffic load for the gateway.
   • BTo enable the switches to synchronize their MAC address tables.
   • CTo provide a single, consistent gateway IP that hosts use regardless of which switch is active.
   • DTo allow the switches to use the virtual IP for management access.
   Reveal Solution Discussion Select an answer first