Configure and Verify the Operation of the Virtual Router Redundancy Protocol POWERSWITCH-CAMPUS-DEPLOY Practice Questions (Page 4)

Questions 16–20

1. 16application · medium

   A network administrator is configuring VRRP on a Dell PowerSwitch for the first time. The administrator configures the virtual router ID, virtual IP, and priority on the interface. What is the minimum additional configuration required to enable VRRP on the interface?

   • AConfigure a VRRP authentication key.
   • BEnable VRRP on the interface with the vrrp enable command.
   • CCreate a VRRP group and assign the interface to it.
   • DSet the VRRP version to 3.
   Reveal Solution Discussion Select an answer first
2. 17foundation · easy

   What is the primary purpose of VRRP on a Dell PowerSwitch network?

   • ATo filter broadcast traffic between VLANs on the switch
   • BTo dynamically assign IP addresses to end hosts on the LAN
   • CTo provide a redundant default gateway for end hosts by allowing multiple routers to share a virtual IP address
   • DTo enable load balancing of traffic across multiple uplinks to the internet
   Reveal Solution Discussion Select an answer first
4. 18expert · medium

   A network has two Dell PowerSwitch switches in a VRRP group. SW1 is the master with priority 120, and SW2 is the backup with priority 100. Both have preemption enabled. The network administrator wants to ensure that SW1 does not become master again after a failover, even if it recovers, to allow for planned maintenance. What configuration change should be made?

   • ADisable preemption on SW2.
   • BChange the virtual router ID on SW1.
   • CDisable preemption on SW1.
   • DIncrease the priority on SW1 to 150.
   Reveal Solution Discussion Select an answer first
5. 19application · easy

   A network engineer is verifying VRRP on a Dell PowerSwitch. The engineer runs show vrrp and sees that the local switch is in the 'Backup' state. What does this indicate about the switch's role?

   • AThe switch has a higher priority than the current master.
   • BThe switch is actively forwarding traffic for the virtual IP.
   • CThe switch is ready to take over as master if the current master fails.
   • DThe switch is not participating in VRRP.
   Reveal Solution Discussion Select an answer first
6. 20application · medium

   A network engineer is verifying VRRP configuration on a Dell PowerSwitch. The engineer runs show vrrp and sees the virtual MAC address 00:00:5e:00:01:0a. What does the '0a' at the end of this MAC address represent?

   • AThe interface number on which VRRP is configured.
   • BThe priority of the master router.
   • CThe virtual router ID (VRID) in hexadecimal.
   • DThe version of VRRP being used.
   Reveal Solution Discussion Select an answer first