Configure and Verify the Operation of the Virtual Router Redundancy Protocol POWERSWITCH-CAMPUS-DEPLOY Practice Questions (Page 3)

Questions 11–15

1. 11application · easy

   A network engineer is verifying VRRP on a Dell PowerSwitch. The engineer runs show vrrp and sees the following output for VLAN 10: State = Master, Virtual IP = 192.168.10.1, Priority = 120. What can the engineer conclude from this output?

   • AThis switch is not participating in VRRP.
   • BThis switch is currently forwarding traffic for the virtual IP.
   • CThis switch is the backup and will take over if the master fails.
   • DThis switch has a lower priority than the other switch in the group.
   Reveal Solution Discussion Select an answer first
2. 12foundation · easy

   Which show command displays the current VRRP state (master or backup) on a Dell PowerSwitch?

   • Ashow ip interface
   • Bshow protocols
   • Cshow vrrp
   • Dshow running-config
   Reveal Solution Discussion Select an answer first
4. 13expert · medium

   A network administrator is configuring VRRP on two Dell PowerSwitch switches for VLAN 60. The administrator wants to use SW1 as the primary gateway for VLAN 60 and SW2 as the primary gateway for VLAN 70. Both VLANs are on the same pair of switches. What is the best approach to achieve this?

   • AConfigure VRRP with different virtual router IDs for each VLAN, and set SW1's priority higher for VLAN 60 and SW2's priority higher for VLAN 70.
   • BConfigure VRRP on only one switch for both VLANs.
   • CConfigure VRRP with the same virtual router ID for both VLANs, and set SW1's priority higher for both.
   • DUse different virtual IP addresses for each VLAN on the same VRRP group.
   Reveal Solution Discussion Select an answer first
5. 14application · medium

   A Dell PowerSwitch switch (SW1) is the VRRP master for VLAN 20 with priority 120. A second switch (SW2) is the backup with default priority. SW1's uplink to the core fails, but the VRRP interface remains up. SW2 becomes master. After the uplink is restored, SW1 does not regain the master role. What is the most likely cause?

   • AThe virtual router ID is different on SW1 and SW2.
   • BSW1's interface is still down after the uplink restoration.
   • CPreemption is disabled on SW1.
   • DSW2 has a higher priority than SW1.
   Reveal Solution Discussion Select an answer first
6. 15foundation · easy

   What happens when the master router in a VRRP group fails?

   • AThe backup routers elect a new master based on the lowest MAC address
   • BThe virtual IP address is removed from the network
   • CAll traffic is dropped until the master recovers
   • DA backup router with the highest priority becomes the new master
   Reveal Solution Discussion Select an answer first