Configure Routing CCA-APPDS-TRAFFIC-MANAGEMENT Practice Questions (Page 4)

Questions 16–20

1. 16expert · hard

   A Citrix ADC is running OSPF and has learned a route to 10.20.0.0/16 via two different neighbors: one with cost 100 and one with cost 200. The administrator wants to ensure that the route with cost 100 is always preferred, but if that neighbor goes down, the ADC should automatically use the route with cost 200. What should the administrator do?

   • AConfigure OSPF to prefer lower cost routes and rely on OSPF's built-in failover
   • BIncrease the cost of the backup route to 300
   • CDisable OSPF on the backup neighbor
   • DSet a static route with a lower metric than the OSPF route
   Reveal Solution Discussion Select an answer first
2. 17application · medium

   An administrator has two static routes to the same destination network 192.168.20.0/24: one via 10.0.1.1 with a metric of 10, and another via 10.0.2.1 with a metric of 20. The administrator wants the ADC to prefer the route via 10.0.1.1. What should the administrator do?

   • ASet the route priority of the 10.0.1.1 route to a higher value
   • BKeep the metric of the 10.0.1.1 route lower than the 10.0.2.1 route
   • CChange the metric of the 10.0.1.1 route to 30
   • DRemove the route via 10.0.2.1
   Reveal Solution Discussion Select an answer first
4. 18expert · hard

   A Citrix ADC has two paths to the same destination network 10.10.0.0/16: one via 192.168.1.1 (metric 10) and one via 192.168.2.1 (metric 20). The administrator wants to use the 192.168.1.1 path for normal traffic, but automatically switch to 192.168.2.1 if 192.168.1.1 becomes unreachable. The administrator also wants to ensure that the backup route is not used unless the primary fails. What should the administrator do?

   • AConfigure route monitoring on the primary route and keep the metric of the backup route higher
   • BSet the metric of the backup route lower than the primary
   • CEnable OSPF on both routes
   • DRemove the backup route and rely on the default route
   Reveal Solution Discussion Select an answer first
5. 19foundation · easy

   What is the purpose of route monitoring on a Citrix ADC?

   • ATo detect path failures and automatically switch to a backup route
   • BTo log all routing decisions for auditing purposes
   • CTo dynamically adjust route metrics based on network congestion
   • DTo automatically add new routes to the routing table
   Reveal Solution Discussion Select an answer first
6. 20foundation · easy

   In the Citrix ADC GUI, where can you view the routing table?

   • ATraffic Management > Load Balancing > Virtual Servers
   • BNetwork > IPs > IP Configuration
   • CSystem > Network > Routes
   • DSystem > Diagnostics > Routes
   Reveal Solution Discussion Select an answer first