Configure Routing CCA-APPDS-TRAFFIC-MANAGEMENT Practice Questions (Page 2)

Questions 6–10

1. 6foundation · easy

   What is the primary benefit of using a dynamic routing protocol like OSPF on a Citrix ADC?

   • AIt eliminates the need for a default route
   • BIt reduces the amount of bandwidth used for routing updates
   • CRoutes are automatically updated when network topology changes
   • DIt provides a more secure routing table than static routes
   Reveal Solution Discussion Select an answer first
2. 7application · medium

   A Citrix ADC has a primary static route to a backend network via 10.0.1.1 and a backup route via 10.0.2.1. The administrator wants the ADC to automatically switch to the backup route if the primary next-hop becomes unreachable. What should the administrator configure?

   • ASet a lower metric on the backup route
   • BEnable route monitoring on the primary route
   • CConfigure OSPF on both routes
   • DAdd a static route for the backup next-hop
   Reveal Solution Discussion Select an answer first
4. 8foundation · easy

   What is the purpose of a default route on a Citrix ADC?

   • ATo load-balance traffic across multiple gateways
   • BTo provide a route for traffic destined to networks that are not explicitly defined in the routing table
   • CTo automatically learn routes from neighboring routers
   • DTo route traffic to networks that are explicitly defined in the routing table
   Reveal Solution Discussion Select an answer first
5. 9application · medium

   A Citrix ADC is deployed in a network with multiple routers running OSPF. The administrator wants the ADC to participate in OSPF and automatically learn routes to backend subnets. The ADC is connected to a router at 10.10.10.1 in area 0. What must the administrator configure on the ADC?

   • AEnable RIP on the ADC and add the interface to area 0
   • BConfigure a default route to 10.10.10.1 and enable OSPF on the loopback interface
   • CAdd a static route for the backend subnets with next-hop 10.10.10.1
   • DEnable OSPF on the ADC and add the interface to area 0
   Reveal Solution Discussion Select an answer first
6. 10foundation · easy

   Which CLI command is used to display the routing table on a Citrix ADC?

   • Aprint route
   • Bdisplay route
   • Cshow route
   • Dlist route
   Reveal Solution Discussion Select an answer first