Configure Network Topologies CCA-APPDS-TRAFFIC-MANAGEMENT Practice Questions (Page 1)

Questions 1–5

1. 1foundation · easy

   What is the purpose of assigning a subnet mask to an IP address on a Citrix ADC interface?

   • ATo determine the physical location of the device
   • BTo encrypt the IP address for security
   • CTo specify the default gateway for the interface
   • DTo identify which part of the IP address is the network and which part is the host
   Reveal Solution Discussion Select an answer first
2. 2foundation · easy

   A Citrix ADC is configured with a static route to a server subnet, but traffic is still not reaching the servers. What is the first thing to verify?

   • AThat the ADC's management interface is enabled
   • BThat the ADC has a DNS server configured
   • CThat the server subnet is on the same VLAN as the ADC
   • DThat the next-hop IP address in the static route is reachable from the ADC
   Reveal Solution Discussion Select an answer first
4. 3expert · hard

   You are designing a high-availability (HA) pair of Citrix ADCs in a two-arm topology. The two ADCs are connected via a dedicated sync link. The client-facing interfaces are on VLAN 10 (192.168.10.0/24) and the server-facing interfaces are on VLAN 20 (192.168.20.0/24). The HA pair uses a floating (virtual) IP for the client-facing side. Which additional configuration is required to ensure that the server-facing side also fails over correctly and that return traffic from the backend servers reaches the active ADC?

   • AConfigure the backend servers to use the primary ADC's server-facing IP as their default gateway, and rely on the sync link for failover.
   • BPlace the server-facing interfaces on the same VLAN as the client-facing interfaces to simplify failover.
   • CConfigure a floating IP on the server-facing interface and ensure the backend servers use the floating IP as their default gateway.
   • DUse a separate HA pair for the server-facing side, with its own sync link and floating IP.
   Reveal Solution Discussion Select an answer first
5. 4application · medium

   A Citrix ADC in a one-arm topology is configured with a single interface on VLAN 10 (192.168.10.0/24). The ADC has an IP of 192.168.10.10/24 and the backend servers are on 192.168.20.0/24, reachable via a router at 192.168.10.1. Clients can reach the virtual server on the ADC, but the ADC cannot reach the backend servers. What is the most likely cause?

   • AThe ADC is missing a static route to the 192.168.20.0/24 network via 192.168.10.1.
   • BThe backend servers are configured with a default gateway of 192.168.20.1, which is unreachable.
   • CThe virtual server is configured with the wrong service type, so it drops backend traffic.
   • DThe ADC's interface is bound to the wrong VLAN, so it cannot send traffic to the router.
   Reveal Solution Discussion Select an answer first
6. 5foundation · easy

   How does a high availability (HA) pair of Citrix ADCs affect the network topology?

   • AIt requires each ADC to be on a separate VLAN.
   • BIt eliminates the need for a default gateway.
   • CIt requires a separate management network for each ADC.
   • DIt adds redundancy by allowing one ADC to take over if the other fails.
   Reveal Solution Discussion Select an answer first