Configure Network Topologies CCA-APPDS-TRAFFIC-MANAGEMENT Practice Questions (Page 2)

Questions 6–10

1. 6foundation · easy

   A Citrix ADC cannot reach a server on a directly connected subnet. What is the most likely cause related to IP configuration?

   • AThe ADC's IP address is on a different subnet than the server.
   • BThe ADC's DNS settings are incorrect.
   • CThe default gateway is misconfigured.
   • DThe ADC's VLAN configuration is correct but the interface is down.
   Reveal Solution Discussion Select an answer first
2. 7foundation · easy

   When configuring network interfaces on a Citrix ADC, what is the purpose of creating a link aggregation (bond) of multiple interfaces?

   • ATo assign multiple IP addresses to a single interface
   • BTo isolate management traffic from data traffic
   • CTo increase bandwidth and provide redundancy
   • DTo enable the interface to operate in half-duplex mode
   Reveal Solution Discussion Select an answer first
4. 8foundation · easy

   Which network topology connects every device directly to a central device, such as a switch, so that all data passes through that central point?

   • AMesh topology
   • BBus topology
   • CStar topology
   • DRing topology
   Reveal Solution Discussion Select an answer first
5. 9foundation · easy

   Which network topology is characterized by each device having a direct connection to every other device, providing the highest level of redundancy?

   • AStar topology
   • BRing topology
   • CBus topology
   • DMesh topology
   Reveal Solution Discussion Select an answer first
6. 10foundation · easy

   A Citrix ADC has an IP address of 192.168.1.10 with a subnet mask of 255.255.255.0. Which of the following IP addresses is on the same subnet?

   • A192.168.1.200
   • B10.0.0.10
   • C192.168.0.10
   • D192.168.2.10
   Reveal Solution Discussion Select an answer first