Configure Network Topologies CCA-APPDS-TRAFFIC-MANAGEMENT Practice Questions (Page 3)

Questions 11–15

1. 11application · medium

   A Citrix ADC in a two-arm topology is configured with client-facing interface on VLAN 10 (192.168.10.0/24) and server-facing interface on VLAN 20 (192.168.20.0/24). Clients can reach the virtual server, but the ADC cannot reach the backend servers on 192.168.20.0/24. The ADC's server-facing interface has IP 192.168.20.10/24. What is the most likely cause?

   • AThe backend servers are on a different subnet than the ADC's server-facing interface.
   • BThe virtual server is configured with the wrong protocol, so it cannot forward traffic to the backend.
   • CThe ADC is missing a default route to the internet.
   • DThe server-facing interface is bound to the wrong VLAN, so it cannot communicate with the backend servers.
   Reveal Solution Discussion Select an answer first
2. 12foundation · easy

   In a Citrix ADC one-arm deployment, how is the appliance connected to the network?

   • AWith a dedicated management interface and a separate data interface.
   • BWith two separate network cables, one for client traffic and one for server traffic.
   • CWith a single network cable connected to a switch, and all traffic enters and leaves through that same interface.
   • DWith a wireless connection to the network.
   Reveal Solution Discussion Select an answer first
4. 13application · medium

   You are configuring a Citrix ADC with two interfaces. Interface 0/1 is connected to a switch port configured as an access port on VLAN 10. Interface 0/2 is connected to a switch port configured as an access port on VLAN 20. You need to ensure that the ADC can route between VLAN 10 and VLAN 20. What should you do on the ADC?

   • ALeave both interfaces untagged and assign IPs from VLAN 10 and VLAN 20 to the interfaces.
   • BCreate a single VLAN on the ADC that spans both interfaces and assign one IP to the VLAN.
   • CBind both interfaces to VLAN 10 and assign IPs from VLAN 10 and VLAN 20 to the interfaces.
   • DBind interface 0/1 to VLAN 10 and interface 0/2 to VLAN 20, then assign IPs from the respective subnets to each interface.
   Reveal Solution Discussion Select an answer first
5. 14expert · hard

   You are deploying a Citrix ADC HA pair in a two-arm topology. The client-facing interfaces are on VLAN 10 (192.168.10.0/24) and the server-facing interfaces are on VLAN 20 (192.168.20.0/24). The HA pair uses floating IPs for both sides. The backend servers are configured with a default gateway of 192.168.20.1. What happens to backend return traffic when the active ADC fails over to the standby?

   • AThe sync link forwards the backend return traffic to the new active ADC.
   • BThe backend servers continue to send traffic to the failed ADC's IP, causing a connectivity outage until the servers are reconfigured.
   • CThe floating IP on the server-facing interface moves to the new active ADC, and backend return traffic is sent to it.
   • DThe backend servers must be manually updated to use the new active ADC's IP address.
   Reveal Solution Discussion Select an answer first
6. 15foundation · easy

   What is the purpose of configuring VLANs on a Citrix ADC network interface?

   • ATo segment traffic into separate logical networks on the same physical link
   • BTo increase the physical speed of the interface
   • CTo enable the interface to connect to multiple switches simultaneously
   • DTo replace the need for IP addresses on the interface
   Reveal Solution Discussion Select an answer first