4.2 Troubleshoot IOS XE Dial Plans Such as Dial Peer Matching, Translation Rules, SIP Profiles, and Tenants 350-801 Practice Questions (Page 1)

Questions 1–5

1. 1foundation · easy

   What is the primary purpose of a translation rule in an IOS XE voice gateway dial plan?

   • ATo specify the SIP trunk that a call should use for outbound routing.
   • BTo manipulate the called or calling number by adding, deleting, or changing digits.
   • CTo define the codec and quality of service for a voice call.
   • DTo route calls to different destinations based on the time of day.
   Reveal Solution Discussion Select an answer first
2. 2application · medium

   A service provider wants to offer different dial plans to two tenants on the same IOS XE gateway. Tenant A should be able to dial 9 to get an outside line, while Tenant B should not. What is the most efficient way to achieve this?

   • AUse the same dial peer for both tenants but with different session targets
   • BCreate separate dial peers for each tenant with different destination patterns and apply them to the respective tenants
   • CConfigure a SIP profile that blocks calls to 9 for Tenant B
   • DUse a single dial peer with a translation rule that adds a prefix for Tenant B
   Reveal Solution Discussion Select an answer first
4. 3foundation · easy

   Which dial peer matching criterion is used to match an inbound call based on the number that the caller originally dialed?

   • Adestination-pattern
   • Bincoming called-number
   • Canswer-address
   • Dsession target
   Reveal Solution Discussion Select an answer first
5. 4foundation · easy

   Which IOS XE command is used to apply a translation rule to an outbound dial peer?

   • Atranslate-outgoing
   • Btranslate-incoming
   • Ctranslation-rule
   • Dvoice translation-profile
   Reveal Solution Discussion Select an answer first
6. 5application · medium

   An administrator notices that inbound calls from a specific SIP trunk are being matched to the wrong outbound dial peer. The calls are destined for numbers starting with 555, but the gateway is routing them to a dial peer with destination pattern 5... instead of the more specific 555.... What is the most likely cause?

   • AThe SIP profile on the inbound dial peer is modifying the Request-URI
   • BThe outbound dial peer with destination pattern 555.... is not associated with the same tenant
   • CThe outbound dial peer with destination pattern 555.... is not configured with the correct session target
   • DThe inbound dial peer is applying a translation rule that changes the called number before outbound matching
   Reveal Solution Discussion Select an answer first