A network engineer is configuring LLQ for a voice deployment. The engineer wants to ensure that voice traffic is given strict priority but also wants to limit the amount of voice traffic that can use the priority queue to prevent starvation of other traffic. Which configuration achieves this?

class VOICE priority percent 50

class VOICE police 384000 bandwidth 384

A network administrator is troubleshooting voice quality issues on a WAN link. The LLQ policy has a voice class with priority 512. The show policy-map interface command shows that the voice class is experiencing drops. What is the most likely cause of these drops?

The policy is applied in the wrong direction

The interface bandwidth is set too high

Voice traffic is exceeding the 512 kbps priority policer

The voice class is not matching any traffic

What is the primary purpose of assigning the priority command to a class in a policy map?

To guarantee a minimum bandwidth for the class

To limit the maximum rate of the class

To provide strict priority scheduling for the class

To mark traffic with a specific DSCP value

CiscoCertified Network Professional Collaboration

Domain 6Objective 4

6.4 Configure LLQ (class Map, Policy Map, Service Policy) 350-801 Practice Questions (Page 1)

Part of the Media and QoS domain, which accounts for 10% of the 350-801 exam. Cisco does not publish an official question count, but from its 120-minute exam (~50–80 total, ~5–8 in this domain), expect 1–2 from this objective — we provide 16 practice questions to prepare you well beyond it. (estimate)

16questions here

4free pages

5concepts

10%of the exam

Questions 1–5

1application · medium
A network engineer is configuring LLQ for a voice deployment. The engineer wants to ensure that voice traffic is given strict priority but also wants to limit the amount of voice traffic that can use the priority queue to prevent starvation of other traffic. Which configuration achieves this?
Select an answer first
2application · medium
A network administrator is troubleshooting voice quality issues on a WAN link. The LLQ policy has a voice class with priority 512. The show policy-map interface command shows that the voice class is experiencing drops. What is the most likely cause of these drops?
Select an answer first
3foundation · easy
Which command is used within a policy map to give a class strict priority in Low Latency Queuing?
Select an answer first
4foundation · easy
What is the primary purpose of assigning the priority command to a class in a policy map?
Select an answer first
5foundation · easy
Which show command displays the packet statistics for each class within a policy map applied to an interface?
Select an answer first

Finished these 5 questions?

Review the revealed explanations, or continue through the curriculum.

Next 5 questions →Back to 350-801

Free Basic Practice is a study aid with revealable answers — not a scored exam. Examers.io is independent and not affiliated with or endorsed by Cisco. “350-801” is a trademark of its owner, used for identification only.

6.4 Configure LLQ (class Map, Policy Map, Service Policy) 350-801 Practice Questions (Page 1)

Questions 1–5

A network engineer is configuring LLQ for a voice deployment. The engineer wants to ensure that voice traffic is given strict priority but also wants to limit the amount of voice traffic that can use the priority queue to prevent starvation of other traffic. Which configuration achieves this?

A network administrator is troubleshooting voice quality issues on a WAN link. The LLQ policy has a voice class with priority 512. The show policy-map interface command shows that the voice class is experiencing drops. What is the most likely cause of these drops?

Which command is used within a policy map to give a class strict priority in Low Latency Queuing?

What is the primary purpose of assigning the priority command to a class in a policy map?

Which show command displays the packet statistics for each class within a policy map applied to an interface?

Keep studying — Media and QoS