4.1 Deploy CMX and Cisco Spaces on a Wireless Network 300-430 Practice Questions (Page 6)

Questions 26–30

1. 26foundation · easy

   What must be configured on a wireless controller to allow CMX to receive location data?

   • AA RADIUS server for client authentication
   • BA new SSID with a captive portal
   • CAn ACL that permits HTTP traffic from CMX
   • DThe CMX server as a Mobility Services Engine (MSE) in the controller's configuration
   Reveal Solution Discussion Select an answer first
2. 27expert · medium

   A company has a Cisco 5520 controller running AireOS and a CMX appliance. They added the CMX as an MSE and enabled the location service, but the CMX dashboard shows no data. The CMX and controller are on different subnets. What is the most likely cause?

   • AThe access points are not broadcasting the SSID.
   • BThe controller's location service is not enabled.
   • CThe CMX is not licensed for location services.
   • DThere is a firewall blocking TCP port 16113 between the controller and CMX.
   Reveal Solution Discussion Select an answer first
4. 28foundation · easy

   What network requirement must be met for Cisco Spaces to receive data from your wireless infrastructure?

   • AA dedicated MPLS circuit to the Cisco cloud
   • BThe wireless controllers must be able to reach the Cisco Spaces cloud over the internet
   • CA VPN tunnel must be established between the local network and Cisco Spaces
   • DThe access points must be configured with a static public IP address
   Reveal Solution Discussion Select an answer first
5. 29application · medium

   An administrator has onboarded Cisco Spaces and is configuring a Cisco 9800 controller to send location data. Which configuration is required on the controller to enable the Spaces connector?

   • AConfigure the controller to send syslog messages to the Spaces cloud.
   • BSet the controller's NTP server to the Cisco Spaces NTP server.
   • CEnable the Cisco Spaces connector in the controller's location services configuration and provide the Spaces API key.
   • DCreate a new SSID with a location tag for Spaces.
   Reveal Solution Discussion Select an answer first
6. 30application · medium

   A company is running CMX and wants to add Cisco Spaces. They have a single Catalyst 9800 controller. The administrator has configured both CMX and Spaces as location receivers on the controller. However, only CMX is receiving data; Spaces shows no data. What is the most likely cause?

   • AThe controller only supports one location receiver at a time.
   • BThe SSID location setting is only enabled for CMX.
   • CCMX is consuming all the location data and not leaving any for Spaces.
   • DThe Spaces receiver is configured with the wrong shared secret.
   Reveal Solution Discussion Select an answer first