4.1 Deploy CMX and Cisco Spaces on a Wireless Network 300-430 Practice Questions (Page 2)

Questions 6–10

1. 6foundation · easy

   Which service must be activated on Cisco CMX to enable location tracking?

   • AThe Presence Service
   • BThe Location Service
   • CThe Analytics Service
   • DThe Notification Service
   Reveal Solution Discussion Select an answer first
2. 7application · medium

   After configuring CMX and Cisco Spaces, an administrator wants to verify that location data is accurate. Which method should they use?

   • AConfirm that the CMX and Spaces are synchronized with the same NTP server.
   • BCheck the controller's syslog for location events.
   • CVerify that the access points are sending SNMP traps to CMX.
   • DWalk a client device through the facility and compare its reported location on the CMX dashboard or Spaces dashboard with known physical positions.
   Reveal Solution Discussion Select an answer first
4. 8application · medium

   A manufacturing company wants to deploy Cisco Spaces for location analytics. They have a mix of Catalyst 9800 and older AireOS controllers. The administrator is concerned about compatibility. What should the administrator verify before onboarding?

   • ACheck that all controllers run a software version supported by Cisco Spaces.
   • BReplace all AireOS controllers with Catalyst 9800 to ensure compatibility.
   • CEnsure that all access points are running the same firmware version.
   • DDeploy CMX in front of the AireOS controllers to translate data.
   Reveal Solution Discussion Select an answer first
5. 9application · medium

   A company has onboarded Cisco Spaces and connected their Cisco 9800 controller. They want to verify that location data is being received by Cisco Spaces. Which step should they take to validate the data flow?

   • ARun a ping from the controller to the Cisco Spaces cloud endpoint.
   • BCheck the Cisco Spaces dashboard for active clients and their locations.
   • CVerify that the controller's syslog messages are being sent to Cisco Spaces.
   • DConfirm that the access points are sending SNMP traps to Cisco Spaces.
   Reveal Solution Discussion Select an answer first
6. 10application · medium

   An administrator has just installed the CMX virtual appliance and completed the initial setup wizard. The CMX is on the same Layer 2 network as the wireless LAN controller. The administrator wants to enable location tracking for the wireless network. Which configuration step is required on the wireless LAN controller to allow CMX to receive location data?

   • AEnable the CMX service on the controller's management interface and set the CMX to receive data on port 161 (SNMP).
   • BConfigure the controller to send syslog messages to the CMX IP address for all wireless client events.
   • CAdd the CMX as a Mobility Services Engine (MSE) in the controller's Mobility Services configuration and set the appropriate service type to Location.
   • DCreate a new SSID with a location tag and bind it to the CMX appliance.
   Reveal Solution Discussion Select an answer first