4.1 Deploy CMX and Cisco Spaces on a Wireless Network 300-430 Practice Questions (Page 1)

Questions 1–5

1. 1application · medium

   After deploying CMX, an administrator wants to validate location accuracy. The administrator has placed test clients at known locations and is comparing the reported positions. The reported positions are consistently offset by about 10 meters in one direction. What is the most likely cause?

   • AThe clients are using 2.4 GHz instead of 5 GHz.
   • BThe access point locations on the floor map are incorrect.
   • CThe location service is set to 'best effort' instead of 'high accuracy'.
   • DThe CMX server clock is not synchronized with the controller.
   Reveal Solution Discussion Select an answer first
2. 2application · medium

   An administrator is integrating CMX with a Cisco 9800 controller. They have completed the CMX installation and added the CMX as an MSE in the controller. However, the CMX dashboard shows no location data. What is the most likely cause?

   • AThe CMX appliance is not licensed for location services.
   • BThe access points are not broadcasting their SSID.
   • CThe CMX is on a different subnet than the controller.
   • DThe controller's location service is not enabled for the CMX.
   Reveal Solution Discussion Select an answer first
4. 3application · medium

   After deploying CMX and integrating it with the wireless LAN controller, the administrator wants to validate that location tracking is working correctly. Which action should the administrator take to verify that CMX is receiving and processing location data?

   • ARun a ping from the CMX to the controller's management IP to verify connectivity.
   • BVerify that the controller's syslog messages are being forwarded to CMX on the correct port.
   • CConfirm that the access points are sending SNMP traps to CMX for every client association.
   • DCheck the CMX dashboard for active clients and compare their reported locations with known physical positions.
   Reveal Solution Discussion Select an answer first
5. 4application · medium

   A retail chain is deploying CMX for location analytics. Their wireless network uses Catalyst 9800 controllers and Aironet access points. The network team has already configured the controllers for management via a dedicated VLAN. During the CMX installation, the installer notices that the CMX appliance cannot reach the controllers' management IP addresses. Which prerequisite is most likely missing?

   • AThe access points are not configured with a location beacon.
   • BThe CMX appliance is not on the same subnet as the controllers.
   • CThe network firewall is blocking TCP port 443 between the CMX and the controllers.
   • DThe controllers are not configured to send location data to CMX via the Mobility Express protocol.
   Reveal Solution Discussion Select an answer first
6. 5expert · medium

   An enterprise is running CMX and wants to add Cisco Spaces. They have a mix of AireOS and IOS XE controllers. They want to minimize the number of data paths and avoid duplicate location data. What is the best deployment strategy?

   • AConnect AireOS controllers to CMX and IOS XE controllers directly to Spaces.
   • BDeploy a second CMX for Spaces and keep the existing CMX for on-premises.
   • CConnect all controllers directly to Spaces and disable CMX.
   • DUse CMX as the single aggregation point for all controllers and forward data to Spaces.
   Reveal Solution Discussion Select an answer first