Configure ONTAP System Networking CERTIFIED-STORAGE-INSTALLATION-ENGINEER-ONTAP Practice Questions (Page 4)

Questions 16–20

1. 16foundation · easy

   Which command is used to create a new data LIF in ONTAP?

   • Anetwork vlan create
   • Bnetwork ifgrp create
   • Cnetwork interface create
   • Dnetwork port create
   Reveal Solution Discussion Select an answer first
2. 17foundation · easy

   What is the purpose of specifying a home node and home port when creating a LIF?

   • ATo define the default location where the LIF will reside and serve data
   • BTo restrict the LIF to only that node and port permanently
   • CTo assign the LIF to a specific broadcast domain
   • DTo set the LIF's IP address and netmask
   Reveal Solution Discussion Select an answer first
4. 18application · medium

   An administrator is configuring a new ONTAP node with four 10GbE ports. The node will host NFS data LIFs that must tolerate a single physical port failure without losing connectivity. The administrator wants to use link aggregation to increase throughput. What should the administrator do?

   • AEnable the 'network port modify -auto-revert' option on each port.
   • BCreate an interface group (ifgrp) with all four ports and assign the data LIFs to the ifgrp.
   • CAssign each LIF to a different physical port and rely on the network switch for failover.
   • DCreate two separate VLANs on each port and assign LIFs to each VLAN.
   Reveal Solution Discussion Select an answer first
5. 19application · medium

   A client reports that they cannot reach a data LIF on an ONTAP cluster. The LIF is up and shows as 'home' in the output of 'network interface show'. The administrator can ping the LIF's IP address from the cluster's node management LIF. What should the administrator do next to isolate the problem?

   • ARun 'network ping -lif <data_lif> -destination <client_ip>' from the node hosting the data LIF.
   • BReboot the node to reset the LIF's network stack.
   • CCheck the client's ARP cache to see if the LIF's MAC address is present.
   • DDelete and recreate the LIF with the same IP address.
   Reveal Solution Discussion Select an answer first
6. 20foundation · easy

   Which command is used to add a static route in ONTAP?

   • Anetwork interface create
   • Bnetwork route create
   • Cnetwork port ifgrp create
   • Dnetwork vlan create
   Reveal Solution Discussion Select an answer first