Configure ONTAP System Networking CERTIFIED-STORAGE-INSTALLATION-ENGINEER-ONTAP Practice Questions (Page 3)

Questions 11–15

1. 11foundation · easy

   Which ONTAP LIF type is used for cluster-wide administration and is typically created on every node?

   • ACluster management LIF
   • BData LIF
   • CIntercluster LIF
   • DNode management LIF
   Reveal Solution Discussion Select an answer first
2. 12foundation · easy

   What is the purpose of a failover group in ONTAP?

   • ATo define the set of ports and nodes where a LIF can fail over
   • BTo provide isolated routing domains
   • CTo segment traffic into separate broadcast domains
   • DTo combine multiple physical ports for increased bandwidth
   Reveal Solution Discussion Select an answer first
4. 13foundation · easy

   What is the purpose of creating VLANs on ONTAP network ports?

   • ATo segment network traffic into separate broadcast domains
   • BTo assign IP addresses to physical ports
   • CTo provide failover for physical network connections
   • DTo combine multiple physical ports for increased bandwidth
   Reveal Solution Discussion Select an answer first
5. 14application · medium

   An ONTAP cluster has a data LIF in IPspace 'nfs' with an IP address of 192.168.10.10/24. The NFS clients are on a different subnet (192.168.20.0/24). The administrator has already created a LIF in the 'nfs' IPspace for the client subnet, but the clients cannot reach the storage. What should the administrator do to enable communication between the two subnets?

   • ACreate a new LIF on the same port with an IP address in the 192.168.20.0/24 subnet.
   • BAdd a static route in the 'nfs' IPspace pointing to the gateway for the 192.168.20.0/24 network.
   • CChange the IPspace of the data LIF to 'default'.
   • DEnable the 'network options' setting for inter-subnet routing.
   Reveal Solution Discussion Select an answer first
6. 15application · medium

   An administrator is setting up a new ONTAP cluster and needs to create a LIF for cluster management. The management network is on a separate subnet from the cluster interconnect. What type of LIF should be created for cluster management?

   • AAn intercluster LIF on a port connected to the management network.
   • BA cluster LIF on the cluster interconnect ports.
   • CA node management LIF on a port connected to the management network.
   • DA data LIF on a port connected to the management network.
   Reveal Solution Discussion Select an answer first