Configure ONTAP System Networking CERTIFIED-STORAGE-INSTALLATION-ENGINEER-ONTAP Practice Questions (Page 1)

Questions 1–5

1. 1foundation · easy

   Which load-balancing method is commonly used with interface groups to distribute traffic based on MAC addresses?

   • Asequential
   • Bround-robin
   • Cip
   • Dmac
   Reveal Solution Discussion Select an answer first
2. 2foundation · easy

   Which ONTAP command is used to display the current status of all network interfaces (LIFs)?

   • Anetwork port show
   • Bnetwork route show
   • Cnetwork vlan show
   • Dnetwork interface show
   Reveal Solution Discussion Select an answer first
4. 3application · medium

   An administrator needs to provide redundant connectivity for a data LIF. The node has two physical ports that are connected to two different switches. The administrator wants to use both ports for the LIF, but the switches do not support link aggregation (LACP). What should the administrator do?

   • ACreate a multi-mode interface group (ifgrp) with the two ports and assign the LIF to the ifgrp.
   • BUse the 'network port modify -mode multi' command on each physical port.
   • CConfigure the two ports as separate LIFs with the same IP address.
   • DCreate two VLANs on the same physical port and assign the LIF to both VLANs.
   Reveal Solution Discussion Select an answer first
5. 4foundation · easy

   Which ONTAP command is used to create an interface group?

   • Anetwork vlan create
   • Bnetwork port ifgrp create
   • Cnetwork interface create
   • Dnetwork route create
   Reveal Solution Discussion Select an answer first
6. 5expert · hard

   An administrator has a single physical port on each node of a two-node cluster. They need to create a data LIF for NFS that can fail over to the other node. The NFS traffic must be on VLAN 100. What is the correct configuration?

   • ACreate a VLAN interface on each node's physical port for VLAN 100, then create a data LIF with a home node and port, and ensure the failover group includes both VLAN interfaces.
   • BCreate a data LIF on the physical port and rely on the switch to tag VLAN 100.
   • CCreate a data LIF on the physical port and set the 'vlan-id' parameter to 100.
   • DCreate a data LIF on the physical port and assign it to VLAN 100 using the 'network interface modify' command.
   Reveal Solution Discussion Select an answer first