Configure ONTAP System Networking CERTIFIED-STORAGE-INSTALLATION-ENGINEER-ONTAP Practice Questions (Page 2)

Questions 6–10

1. 6application · medium

   An administrator is troubleshooting a data LIF that is not reachable from clients. The LIF shows as 'up' in 'network interface show'. The administrator suspects a routing issue. Which command should the administrator use to view the routing table for the IPspace that contains the LIF?

   • Anetwork options route show
   • Bnetwork interface show -routing
   • Cip route show
   • Dnetwork route show -vserver <svm_name>
   Reveal Solution Discussion Select an answer first
2. 7foundation · easy

   Which command is used to test network connectivity from an ONTAP node to a remote host?

   • Anetwork interface show
   • Bnetwork ping
   • Cnetwork traceroute
   • Dnetwork route show
   Reveal Solution Discussion Select an answer first
4. 8foundation · easy

   Which ONTAP LIF type is used to carry data traffic between clusters for features like SnapMirror?

   • ACluster LIF
   • BData LIF
   • CIntercluster LIF
   • DNode management LIF
   Reveal Solution Discussion Select an answer first
5. 9application · medium

   An administrator is configuring a new SVM for a customer that requires strict network isolation from other SVMs on the same cluster. The customer's data traffic must not be routable to other SVMs' networks. What should the administrator do?

   • AUse a different subnet for the SVM's data LIFs.
   • BConfigure a firewall policy on the SVM's data LIFs to block traffic to other SVMs.
   • CCreate a new IPspace for the SVM and assign its data LIFs to that IPspace.
   • DPlace the SVM's data LIFs on a separate VLAN.
   Reveal Solution Discussion Select an answer first
6. 10foundation · easy

   Which command is used to create a VLAN on an ONTAP network port?

   • Anetwork vlan create
   • Bnetwork port ifgrp create
   • Cnetwork route create
   • Dnetwork interface create
   Reveal Solution Discussion Select an answer first