In an EVPN-VXLAN data center, what is the primary purpose of the Inclusive Multicast Ethernet Tag (IMET) route?

To carry the actual multicast data packets between VTEPs in the overlay

To advertise the VTEP's IP address and VNI so that remote VTEPs can build a multicast distribution tree for BUM traffic

To identify the multicast group address and the list of receivers for a specific VNI

To signal the multicast group membership of individual hosts to remote VTEPs

What is the role of the EVPN Type 7 (Multicast Sync) route?

To synchronize multicast state between VTEPs that share a multi-homed Ethernet segment

To provide a backup path for multicast traffic in case of a link failure

To advertise the multicast group address and source to all VTEPs

To signal interest in a specific multicast group from a VTEP

In EVPN, what is the purpose of the Type 6 (Selective Multicast Ethernet Tag) route?

To carry the multicast data packets between VTEPs

To synchronize multicast state between VTEPs in a redundancy group

To signal interest in a specific multicast group from a VTEP

To advertise the VTEP's IP address and VNI for BUM traffic forwarding

Which EVPN multicast mode is most appropriate when the underlay does not support multicast and the network is small or has low BUM traffic volume?

OISM (Optimized Inter-Subnet Multicast)

Juniper NetworksCertified Professional, Data Center (JNCIP-DC)

Domain 4Objective 2

EVPN Multicast JN0-683 Practice Questions (Page 3)

Part of the EVPN-VXLAN Signaling domain, which makes up ~27% of our current practice bank. Juniper Networks does not publish an official question count, but from its 90-minute exam (~35–60 total, ~9–16 in this domain), expect 1–2 from this objective — we provide 18 practice questions to prepare you well beyond it. (estimate)

18questions here

4free pages

6concepts

Questions 11–15

11foundation · easy
In an EVPN-VXLAN data center, what is the primary purpose of the Inclusive Multicast Ethernet Tag (IMET) route?
Select an answer first
12foundation · easy
What is the role of the EVPN Type 7 (Multicast Sync) route?
Select an answer first
13foundation · easy
In EVPN, what is the purpose of the Type 6 (Selective Multicast Ethernet Tag) route?
Select an answer first
14foundation · easy
Which EVPN multicast mode is most appropriate when the underlay does not support multicast and the network is small or has low BUM traffic volume?
Select an answer first
15application · medium
An engineer is troubleshooting an EVPN-VXLAN multicast issue where a receiver is not getting traffic for a specific group. The receiver's IGMP report is visible on the access switch, and the VTEP has learned the group. However, the remote VTEP is not receiving the multicast traffic. Which command should the engineer use to verify the EVPN multicast state on the local VTEP?
Select an answer first

Finished these 5 questions?

Review the revealed explanations, or continue through the curriculum.

Next 5 questions →Back to JN0-683

Free Basic Practice is a study aid with revealable answers — not a scored exam. Examers.io is independent and not affiliated with or endorsed by Juniper Networks. “JN0-683” is a trademark of its owner, used for identification only.