Configure, Monitor, or Troubleshoot OSPF Interfaces and Neighbors JN0-364 Practice Questions (Page 3)

Questions 11–15

1. 11foundation · easy

   What is the purpose of configuring an OSPF interface as passive?

   • ATo suppress OSPF hello packets on the interface
   • BTo increase the OSPF priority on the interface
   • CTo enable OSPF authentication on the interface
   • DTo change the OSPF network type to point-to-point
   Reveal Solution Discussion Select an answer first
2. 12foundation · easy

   Which mismatch will prevent OSPF neighbor adjacency from forming?

   • ADifferent router IDs
   • BDifferent area IDs
   • CDifferent interface costs
   • DDifferent interface priorities
   Reveal Solution Discussion Select an answer first
4. 13foundation · easy

   Which statement is true about a passive OSPF interface?

   • AIt only works on point-to-point links.
   • BIt still advertises the connected subnet into OSPF.
   • CIt requires a higher priority to be effective.
   • DIt does not advertise the connected subnet into OSPF.
   Reveal Solution Discussion Select an answer first
5. 14foundation · easy

   Which command is used to verify that OSPF-learned routes are present in the routing table?

   • Ashow ospf neighbor
   • Bshow ospf interface
   • Cshow route protocol ospf
   • Dshow ospf database
   Reveal Solution Discussion Select an answer first
6. 15application · medium

   Two OSPF routers in area 0 are connected via a point-to-point link. The network engineer runs 'show ospf neighbor' on Router A and sees the neighbor in the ExStart state. The output of 'show ospf interface ge-0/0/0.0' on Router A shows MTU 1500, while Router B's interface shows MTU 9000. What is the most likely cause of the adjacency being stuck in ExStart?

   • AThe OSPF network type is mismatched between the two routers.
   • BThe OSPF hello and dead intervals do not match between the routers.
   • CThe OSPF MTU mismatch prevents the Database Description packets from being exchanged successfully.
   • DThe OSPF area ID is different on the two routers.
   Reveal Solution Discussion Select an answer first