Juniper NetworksCertified Specialist, Service Provider Routing and Switching (JNCIS-SP)
Domain 8Objective 4
Configure, Monitor, or Troubleshoot IPv6 Technologies JN0-364 Practice Questions (Page 4)
Part of the IPv6 domain, which makes up ~5% of our current practice bank. Juniper Networks does not publish an official question count, but from its 90-minute exam (~35–60 total, ~2–3 in this domain), expect 1–1 from this objective — we provide 21 practice questions to prepare you well beyond it. (estimate)
21questions here
5free pages
7concepts
Questions 16–20
- 16
A network engineer is troubleshooting IPv6 connectivity on a Junos router. The router cannot ping a remote IPv6 address. The engineer suspects that the router does not have a route to the destination. Which command should be used to verify the routing table entry for the destination?
Select an answer first - 17
Which Neighbor Discovery Protocol (NDP) message type is used by a host to determine the link-layer address of a neighbor?
Select an answer first - 18
Which IPv6 routing protocol uses the same SPF algorithm as OSPFv2 but runs over IPv6 and uses link-local addresses for neighbor discovery?
Select an answer first - 19
Which IPv6 tunneling mechanism automatically derives the IPv6 prefix from the IPv4 address of the tunnel endpoint and is designed to provide IPv6 connectivity over the IPv4 Internet without manual tunnel configuration?
Select an answer first - 20
A network engineer is troubleshooting an OSPFv3 adjacency that is stuck in ExStart state on a Junos router. The engineer suspects an MTU mismatch. Which command should be used to verify the MTU on the OSPFv3 interface?
Select an answer first
Finished these 5 questions?
Review the revealed explanations, or continue through the curriculum.
Free Basic Practice is a study aid with revealable answers — not a scored exam. Examers.io is independent and not affiliated with or endorsed by Juniper Networks. “JN0-364” is a trademark of its owner, used for identification only.