Juniper NetworksCertified Specialist, Service Provider Routing and Switching (JNCIS-SP)
Domain 8Objective 4
Configure, Monitor, or Troubleshoot IPv6 Technologies JN0-364 Practice Questions (Page 1)
Part of the IPv6 domain, which makes up ~5% of our current practice bank. Juniper Networks does not publish an official question count, but from its 90-minute exam (~35–60 total, ~2–3 in this domain), expect 1–1 from this objective — we provide 21 practice questions to prepare you well beyond it. (estimate)
21questions here
5free pages
7concepts
Questions 1–5
- 1
Which IPv6 transition mechanism allows a network to run both IPv4 and IPv6 protocols simultaneously on the same infrastructure?
Select an answer first - 2
Which IPv6 transition mechanism is used to allow IPv6-only hosts to communicate with IPv4-only servers by translating the IP headers?
Select an answer first - 3
A service provider is implementing NAT64 to allow IPv6-only clients to access IPv4-only servers. The provider has a limited IPv4 address pool and wants to minimize the number of IPv4 addresses used. Which NAT64 configuration should be used?
Select an answer first - 4
A network engineer is troubleshooting an IPv6 tunnel between two Junos routers. The tunnel is configured as a 6in4 tunnel, but traffic is not passing. The engineer suspects the tunnel is down. Which command should be used to verify the operational state of the tunnel interface?
Select an answer first - 5
Which statement is true about configuring BGP for IPv6 on Junos?
Select an answer first
Finished these 5 questions?
Review the revealed explanations, or continue through the curriculum.
Free Basic Practice is a study aid with revealable answers — not a scored exam. Examers.io is independent and not affiliated with or endorsed by Juniper Networks. “JN0-364” is a trademark of its owner, used for identification only.