Install and Initialize a Dell Unity XT Storage System UNITY-DEPLOY Practice Questions (Page 5)

Questions 21–25

1. 21foundation · easy

   Which cabling practice is correct when connecting a Dell Unity XT system?

   • AUse fiber optic cables for all connections, including management
   • BConnect both power supplies to the same PDU to simplify cable management
   • CRoute cables in front of the system to allow easy access to the rear
   • DLabel cables at both ends to identify their purpose and connection points
   Reveal Solution Discussion Select an answer first
2. 22foundation · easy

   Which of the following is a valid method to verify the health of a Dell Unity XT system after initialization?

   • ARun a full disk surface scan
   • BReboot the system to ensure it starts cleanly
   • CCheck the status LEDs on the front and rear of the system
   • DCheck the temperature of the exhaust air
   Reveal Solution Discussion Select an answer first
4. 23foundation · easy

   After powering on a Dell Unity XT system, what should you verify to confirm that components are starting up properly?

   • AThe network ports are blinking rapidly
   • BThe power LED on each component is solid green
   • CAll fans are spinning at maximum speed
   • DThe system emits a single audible beep
   Reveal Solution Discussion Select an answer first
5. 24foundation · easy

   Which of the following is a required environmental prerequisite for installing a Dell Unity XT storage system?

   • AA raised floor with at least 60 cm of clearance
   • BA dedicated 20-amp circuit for each power supply
   • CA static-free wrist strap for every installer
   • DAn ambient temperature within the operating range specified in the hardware guide
   Reveal Solution Discussion Select an answer first
6. 25expert · hard

   A technician is rack mounting a Dell Unity XT 480. The rack has threaded holes, but the technician only has cage nuts available. What should the technician do?

   • AConvert the threaded holes to square holes using a file.
   • BUse the cage nuts in the threaded holes; they will fit.
   • CObtain the correct screws for threaded holes and use them directly.
   • DUse zip ties to secure the rails to the rack posts.
   Reveal Solution Discussion Select an answer first