Install and Initialize a Dell Unity XT Storage System UNITY-DEPLOY Practice Questions (Page 3)

Questions 11–15

1. 11application · medium

   A technician is rack mounting a Dell Unity XT 380. The rack has square holes, and the technician is using cage nuts. What is the correct procedure for installing the rails?

   • AInstall the cage nuts in the front and rear posts, then attach the rails to the cage nuts.
   • BUse clip nuts instead of cage nuts for square-hole racks.
   • CSkip the rails and place the system directly on a shelf in the rack.
   • DAttach the rails directly to the square holes using self-tapping screws.
   Reveal Solution Discussion Select an answer first
2. 12expert · hard

   An administrator is configuring a Dell Unity XT system via Unisphere. The management IP address is set, but the administrator cannot access Unisphere from the workstation. The workstation is on the same subnet as the management IP. What is the most likely cause?

   • AThe management IP address is not in the same subnet as the workstation.
   • BThe management port is not connected to the network.
   • CThe default gateway is not set correctly.
   • DThe system name is not set correctly.
   Reveal Solution Discussion Select an answer first
4. 13application · medium

   An administrator is performing the initial configuration of a Dell Unity XT system via Unisphere. They need to set the system name and time zone. What is the correct sequence of steps?

   • ASet the time zone only; the system name is optional.
   • BSet the system name and time zone first, then the management IP address.
   • CSet the management IP address first, then the system name and time zone.
   • DSet the system name only; the time zone is automatically detected.
   Reveal Solution Discussion Select an answer first
5. 14foundation · easy

   What is the correct power-on sequence for a Dell Unity XT system?

   • APower on the management station first, then the storage system
   • BPower on the disk enclosure(s) first, then the storage processors
   • CPower on the storage processors first, then the disk enclosure
   • DPower on all components simultaneously using a single switch
   Reveal Solution Discussion Select an answer first
6. 15application · medium

   A technician is unpacking a Dell Unity XT 480. After removing the outer packaging, they notice the system is on a pallet with anti-static packaging. What is the correct next step before rack mounting?

   • AConnect the power cables to the system and test the power supply before rack mounting.
   • BRemove the anti-static packaging and place the system on a stable, non-conductive surface.
   • CLift the system by the front handles and place it directly onto the rack rails.
   • DSlide the system into the rack without removing the anti-static packaging to protect it during installation.
   Reveal Solution Discussion Select an answer first