Install SONiC Using the ONIE Manual Method SONIC-DEPLOY Practice Questions (Page 5)

Questions 21–24

1. 21foundation · medium

   Which of the following is a common method to access the ONIE environment on a switch?

   • AUsing a web browser to access the switch's management interface
   • BSending a special command over the network to the switch's management port
   • CConnecting to the switch via SSH to a default IP address
   • DInterrupting the boot process to select ONIE from the boot menu
   Reveal Solution Discussion Select an answer first
2. 22application · easy

   An engineer is installing SONiC on a Dell switch using the ONIE manual method. The engineer has booted into ONIE and wants to install from a local image file located at /tmp/sonic.bin on the switch's filesystem. Which command should the engineer use?

   • Aonie-install -i file:///tmp/sonic.bin
   • Bonie-install /tmp/sonic.bin
   • Conie-install --local /tmp/sonic.bin
   • Donie-install -i /tmp/sonic.bin
   Reveal Solution Discussion Select an answer first
4. 23application · medium

   After a manual ONIE installation of SONiC, the switch reboots. The engineer wants to confirm that SONiC booted successfully. Which observation would provide the strongest confirmation?

   • AThe switch reaches the SONiC login prompt on the console.
   • BThe ONIE prompt appears again after reboot.
   • CThe switch responds to ping on the management IP.
   • DThe switch's fans spin up and the power LED is green.
   Reveal Solution Discussion Select an answer first
5. 24foundation · medium

   After the ONIE installation completes, what message is typically displayed to indicate success?

   • ASONiC is now running
   • BInstallation failed, please retry
   • CImage downloaded successfully
   • DONIE: Installer completed successfully
   Reveal Solution Discussion Select an answer first