Examers.io
ExamsOrganizationsHow it worksPricingHelp & FAQ
Dell Technologies logo

Dell PowerSwitch Campus Deploy

Domain 3Objective 3

Configure and Verify the Operation of the MLAG Solution POWERSWITCH-CAMPUS-DEPLOY Practice Questions (Page 1)

Part of the IPv6 Stacking domain, which accounts for 11% of the POWERSWITCH-CAMPUS-DEPLOY exam.

14questions here
3free pages
4concepts
11%of the exam

Questions 1–5

  1. 1application · medium

    A network administrator has configured MLAG on a pair of Dell PowerSwitch N3248PXE-ON switches. The administrator wants to verify that the MLAG port-channel connected to a downstream access switch is operating correctly and that both peers are forwarding traffic for that port-channel. Which command provides the most direct confirmation that the MLAG port-channel is active on both peers?

    Select an answer first
  2. 2application · medium

    An engineer is configuring MLAG on two Dell PowerSwitch N3048P switches. The engineer has created the MLAG domain and configured the peer-link. The engineer now needs to configure the keepalive link. Which interface type should be used for the keepalive link?

    Select an answer first
  3. 3expert · hard

    A network engineer is troubleshooting an MLAG issue on a pair of Dell PowerSwitch S4128F-ON switches. The 'show mlag detail' output shows that the MLAG domain is up, the peer-link is up, and the keepalive is up. However, the MLAG port-channel connected to a downstream switch is in a 'mismatch' state. What is the most likely cause of this mismatch?

    Select an answer first
  4. 4application · medium

    A campus network uses a pair of Dell PowerSwitch S4128F-ON switches in an MLAG configuration as the access layer. A server is connected to both switches using a single LACP port-channel. The network administrator wants to verify that the MLAG is providing active-active forwarding for the server. Which command should the administrator use to confirm that both switches are forwarding traffic for the server's port-channel?

    Select an answer first
  5. 5foundation · easy

    Which command is used to verify the MLAG peer status on a Dell PowerSwitch?

    Select an answer first
Finished these 5 questions?

Review the revealed explanations, or continue through the curriculum.

Free Basic Practice is a study aid with revealable answers — not a scored exam. Examers.io is independent and not affiliated with or endorsed by Dell Technologies. “POWERSWITCH-CAMPUS-DEPLOY” is a trademark of its owner, used for identification only.