Describe the Operation and Behavior of the MLAG Solution POWERSWITCH-CAMPUS-DEPLOY Practice Questions (Page 1)

Questions 1–5

1. 1foundation · easy

   What is the behavior of an MLAG domain when one of the peer switches completely fails (e.g., power loss)?

   • AThe remaining switch shuts down all MLAG ports to prevent loops
   • BThe downstream device must be reconfigured to use a single link
   • CThe remaining switch continues to forward traffic using the MLAG ports and uplinks
   • DThe remaining switch becomes the root bridge for STP
   Reveal Solution Discussion Select an answer first
2. 2application · medium

   An administrator is troubleshooting an MLAG issue where the MLAG port-channel on a downstream switch is not coming up. The MLAG domain is up, and the peer link is operational. What should the administrator check first?

   • ACheck the VLAN configuration on the downstream switch.
   • BCheck the peer keepalive link status.
   • CCheck the STP state on the downstream switch.
   • DCheck the MLAG port-channel configuration on both MLAG switches.
   Reveal Solution Discussion Select an answer first
4. 3application · medium

   An administrator has configured an MLAG domain on two Dell PowerSwitch switches. They want to verify that the MLAG peers are synchronizing MAC addresses correctly. Which show command provides the most direct evidence of successful MAC synchronization between the MLAG peers?

   • Ashow mlag mac-table
   • Bshow mlag peer-keepalive
   • Cshow mac address-table
   • Dshow mlag detail
   Reveal Solution Discussion Select an answer first
5. 4foundation · easy

   How do the two switches in an MLAG domain synchronize state information such as MAC addresses?

   • AThey exchange state information over the peer link using a proprietary synchronization protocol
   • BThey rely on the downstream device to send updates to both switches
   • CThey use the peer keepalive link to exchange MAC address tables
   • DThey use the Spanning Tree Protocol to share MAC addresses
   Reveal Solution Discussion Select an answer first
6. 5foundation · easy

   When configuring an MLAG domain on Dell PowerSwitch, what is a key configuration step that must be performed on both switches?

   • AAssign the same MLAG domain ID and configure the peer link and peer keepalive
   • BSet the same IP address on both switches for management
   • CConfigure different MLAG domain IDs to allow for redundancy
   • DEnable MLAG only on the primary switch
   Reveal Solution Discussion Select an answer first