An administrator is adding a third switch to an existing two-member OS6 stack. The new switch is the same model and has the same firmware version. After connecting the stacking cables and powering on, the new switch does not join the stack. Which step is most likely required?

Increase the stack priority of the new switch to 15.

Assign a unique stack member number to the new switch.

Disable the stacking feature on the existing members temporarily.

Configure the new switch with the same hostname as the stack.

In OS6 stacking, what is the effect of assigning a higher priority value to a stack member?

It forces the member to be the stack standby

It increases the likelihood of that member being elected as stack master

It increases the forwarding bandwidth of that member

It determines the member's position in the stack topology

What is required to ensure firmware is synchronized across all OS6 stack members?

Firmware must be identical from the factory

The stack master automatically distributes firmware to all members

Manually upgrading each member individually

Firmware synchronization is not supported in OS6

An administrator is troubleshooting an OS6 stack where member 3 is not appearing in the 'show stack' output. The stacking cables are connected, and the switch is powered on. What is the first command to run?

'show interfaces status' on member 3

Dell PowerSwitch Campus Deploy

Domain 8Objective 2

Configure and Verify the Operation of Stacking in OS6 POWERSWITCH-CAMPUS-DEPLOY Practice Questions (Page 4)

Part of the Stacking domain, which accounts for 6% of the POWERSWITCH-CAMPUS-DEPLOY exam.

23questions here

5free pages

8concepts

6%of the exam

Questions 16–20

16foundation · easy
How do you set the priority of a stack member to influence master election in OS6?
Select an answer first
17application · medium
An administrator is adding a third switch to an existing two-member OS6 stack. The new switch is the same model and has the same firmware version. After connecting the stacking cables and powering on, the new switch does not join the stack. Which step is most likely required?
Select an answer first
18foundation · easy
In OS6 stacking, what is the effect of assigning a higher priority value to a stack member?
Select an answer first
19foundation · easy
What is required to ensure firmware is synchronized across all OS6 stack members?
Select an answer first
20application · medium
An administrator is troubleshooting an OS6 stack where member 3 is not appearing in the 'show stack' output. The stacking cables are connected, and the switch is powered on. What is the first command to run?
Select an answer first

Finished these 5 questions?

Review the revealed explanations, or continue through the curriculum.

Next 5 questions →Back to POWERSWITCH-CAMPUS-DEPLOY

Free Basic Practice is a study aid with revealable answers — not a scored exam. Examers.io is independent and not affiliated with or endorsed by Dell Technologies. “POWERSWITCH-CAMPUS-DEPLOY” is a trademark of its owner, used for identification only.