Configure and Verify the Operation of PBR POWERSWITCH-CAMPUS-DEPLOY Practice Questions (Page 3)

Questions 11–13

1. 11foundation · easy

   In a Dell PowerSwitch PBR route map, what does the 'set ip next-hop' command accomplish?

   • AIt defines the destination IP address for packets that match the route map
   • BIt specifies the IP address of the next router to which matching packets should be forwarded
   • CIt adds a static route to the routing table for the matching traffic
   • DIt changes the source IP address of matching packets to the specified address
   Reveal Solution Discussion Select an answer first
2. 12foundation · easy

   When troubleshooting PBR on a Dell PowerSwitch, which command would you use to see whether a route map is applied to a specific interface?

   • Ashow ip pbr interface
   • Bshow running-config interface <interface>
   • Cshow ip route-map
   • Dshow ip interface
   Reveal Solution Discussion Select an answer first
3. 13application · medium

   A network engineer is implementing PBR on a Dell PowerSwitch to route traffic from a specific source to a next-hop. The engineer creates a route map with a match clause that uses an access list. What is the purpose of the access list in this configuration?

   • ATo define which traffic should be affected by the PBR policy.
   • BTo specify the interface where the route map is applied.
   • CTo filter traffic that should be dropped.
   • DTo define the next-hop for the traffic.
   Reveal Solution Discussion Select an answer first