Configure and Verify the Operation of PBR POWERSWITCH-CAMPUS-DEPLOY Practice Questions (Page 1)

Questions 1–5

1. 1application · medium

   A network administrator configures PBR on a Dell PowerSwitch to route traffic from a specific source subnet to a next-hop. After applying the route map, the administrator wants to verify that the PBR is working. Which command should the administrator use to see the number of packets that have matched the route map?

   • Ashow access-lists
   • Bshow route-map
   • Cshow ip policy
   • Dshow ip route
   Reveal Solution Discussion Select an answer first
2. 2application · medium

   A network administrator is configuring PBR on a Dell PowerSwitch. The administrator wants to route traffic from a specific source subnet to a next-hop router. The administrator creates a route map and applies it to the interface. What is the next step to ensure the PBR policy is active?

   • AEnable IP routing on the switch.
   • BConfigure a static route for the same subnet.
   • CReboot the switch to apply the configuration.
   • DVerify the route map is applied to the correct interface and check match counters.
   Reveal Solution Discussion Select an answer first
4. 3application · medium

   A campus network has a mix of traffic: voice traffic from IP phones must use a dedicated MPLS link to the VoIP provider, while all other traffic should use the primary internet link. The network engineer wants to implement PBR on the access switch where the phones connect. What is the first step in the PBR configuration process?

   • AConfigure a static route for voice traffic to the MPLS router.
   • BEnable IP routing globally on the switch.
   • CCreate a route map that matches voice traffic and sets the next-hop to the MPLS router.
   • DApply a route map to the access switch's uplink interface.
   Reveal Solution Discussion Select an answer first
5. 4foundation · easy

   In a Dell PowerSwitch campus network, what is the primary purpose of Policy-Based Routing (PBR)?

   • ATo replace the routing table with a set of static routes for all traffic
   • BTo allow forwarding decisions to be made based on criteria other than the destination IP address
   • CTo increase the speed of the routing table lookup by caching forwarding decisions
   • DTo provide a backup path for the default route in case of link failure
   Reveal Solution Discussion Select an answer first
6. 5foundation · easy

   In Dell PowerSwitch PBR, what is the role of a route map when applied to an interface?

   • AIt defines which routing protocol is used to exchange routes on that interface
   • BIt filters routing updates received from neighboring devices on that interface
   • CIt specifies the set of rules that determine how incoming packets on that interface are forwarded
   • DIt assigns a default gateway for packets that do not match any routing table entry
   Reveal Solution Discussion Select an answer first