Configure and Verify the Operation of PBR POWERSWITCH-CAMPUS-DEPLOY Practice Questions (Page 2)

Questions 6–10

1. 6application · medium

   A network engineer wants to implement PBR on a Dell PowerSwitch to route traffic from a specific source subnet to a next-hop router. The switch is currently using OSPF for dynamic routing. What is the primary advantage of using PBR over a static route for this scenario?

   • APBR is easier to configure than static routes.
   • BPBR is more secure than static routes.
   • CPBR can match traffic based on source IP, while static routes match based on destination only.
   • DPBR automatically fails over to a backup next-hop.
   Reveal Solution Discussion Select an answer first
2. 7expert · hard

   A network engineer is configuring PBR on a Dell PowerSwitch to route traffic from VLAN 20 to a next-hop of 10.0.0.2. The route map is applied to interface Gi1/0/1, which is the access port for VLAN 20. After configuration, traffic from VLAN 20 is not being forwarded to 10.0.0.2. The engineer checks 'show route-map' and sees that the match counters are incrementing. What is the most likely cause of the issue?

   • AThe access list in the route map is incorrect.
   • BThe route map is applied to the wrong interface.
   • CThe next-hop 10.0.0.2 is not reachable from the switch.
   • DThe route map sequence number is too low.
   Reveal Solution Discussion Select an answer first
4. 8application · medium

   An administrator configures PBR on a Dell PowerSwitch to route traffic from a specific source to a next-hop. After applying the route map, the administrator notices that the 'show route-map' command displays match counters that are incrementing, but traffic is not being forwarded to the intended next-hop. What is the most likely cause?

   • AThe route map sequence number is too high.
   • BThe route map is not applied to the correct interface.
   • CThe next-hop IP address is not in the routing table.
   • DThe access list used in the route map is incorrect.
   Reveal Solution Discussion Select an answer first
5. 9foundation · easy

   Which Dell PowerSwitch command displays the route maps that are configured and their match/set clauses?

   • Ashow running-config interface
   • Bshow ip pbr
   • Cshow ip route-map
   • Dshow ip policy
   Reveal Solution Discussion Select an answer first
6. 10foundation · easy

   Which two configuration steps are required to enable PBR on a Dell PowerSwitch interface?

   • ACreate an access list and apply it to the interface
   • BDefine a route map with match and set clauses, then apply it to the interface
   • CCreate a policy map and attach it to the interface
   • DEnable PBR globally and then configure a static route
   Reveal Solution Discussion Select an answer first